GE UX12BS48PSS Installation Instructions

Installation
Instructions
WARNING
To prevent ignition of combustible
materials, the entire back wall above the range
must be protected by a backsplash constructed of
non-combustible material.
This stainless steel backsplash accessory must be
installed in combination with a custom, non-combustible
backsplash built beyond the height of the backsplash.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
for local inspector's use.
IMPORTANT
codes and ordinances.
Note to Installer — Be sure to leave these
instructions with the consumer.
Note to Consumer — Keep these instructions with
your Owner's Manual for future reference.
This kit provides for the installation of a high
backsplash for 30" Ranges and Rangetops.
TOOLS AND MATERIALS REQUIRED
screwdrivers
This Kit Includes
31-2003324 Rev. 0 09-24
— Save these instructions
— Observe all governing
Backsplash
INSTALL BACKSPLASH
WARNING
This backsplash must be securely
fastened to the wall. Failure to do so could result in
damage or personal injury.
range hood according to the installation instructions.
film.
Use a level to pencil a horizontal line on the wall,
gap allows the cover panel to overlap the wall support
panel.
available, plan to use wall anchors (not provided).
with any electrical lines or plumbing.
horizontal line and centered left to right.
near all 4 corners. Use wood screws (provided) or
wall anchors (not provided) to secure the support
panel to the wall.
screws on each side.
Support
Screws