Sigma DIONE Manual

Outdoor self powered sirens

Advertisement

DIONE
OUTDOOR SELF POWERED SIRENS
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DIONE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sigma DIONE

  • Page 1 DIONE OUTDOOR SELF POWERED SIRENS...
  • Page 2: General Specifications

    Description Self-powered and self-protective electronic siren with built-in FLASH, for easy detection of the area from which the alarm comes. It is an ideal combination of stylish design and quality construction and is manufactured under the strictest safety standards. The outer casing is made of high-strength polycarbonate, suitable for outdoor use.
  • Page 3: Siren Alarm Duration

    • gives an alarm lasting five (5) minutes, if the power cables and the cable that gives the alarm command are cut at the same time. Technical Specifications DIONE Power Supply 13.2-14.5 V DC Operational Voltage 13.8 V DC...
  • Page 4: Terminals Description

    Terminals Description TAMPER TAMPER SWITCH CONTACTS POWER SUPPLY INPUT (12V) FOR SIREN ΑΝD FOR BATTERY CHARGING TRIGGER ALARM INPUT CONTROLLED BY THE PANEL SIGN INPUT FOR VISUAL AND / OR AUDIBLE SIGNALING OF THE SYSTEM STATE FLT OUT LOW BATTERY VOLTAGE OUTPUT SPEAKER INPUT FOR CONNECTING THE SPEAKER CABLES “TAMPER”...
  • Page 5 11.5V or the battery is replaced with a new one. Used to inform the user and / or the Signal Reception Center about the system battery status. Installation - Connections SIGMA PANEL To install the siren, please follow the sequence of tasks as described below: 1.
  • Page 6 Caution! The siren protection TAMPER does not activate the siren but the alarm panel. • Connect the power supply contacts of the siren (- 12V +), to the corresponding power outputs of the panel, paying attention to the correct polarity. Caution! For safety reasons and for the correct operation of the siren, a battery must be used.
  • Page 7: Maintenance

    Maintenance You will need to check the proper functioning of the siren at regular intervals to make sure that the siren is not damaged and that it will work normally when needed. The following functions should be checked in every maintenance: 1.
  • Page 8 www.sigmasec.gr...

Table of Contents