sensolus ZA 3510 Installation Manual

Installation and activation manual ZA 3510
Installing the the zone anchor
Attach the zone anchor on the wall
Guidelines for mounting the tracker can be found in the Sensolus documentation center.
Power the zone anchor.
The zone anchor can operate independently on its internal battery or you can connect the zone anchor to
the standard electrical network using a power cable and adapter.
If you use the internal battery you can skip this.
Put the cable onto the connector. Tighten the connection by gently Check if the power cable is connected Plug into the netpower
Only the black plastic piece will go screwing the cable into the connector. well.
into the connector. Do not force this Do not force this as well.
Activation of the zone anchor
Activation of the zone anchors is preferably done with clear skies, and not inside (e.g. factory or warehouse).
Zone anchors are not activated when delivered to your premises. Their subscription in the platform will start within six month of purchase.
Hold a magnet for about 5 You will first see a red LED. Do When the green LED is blinking
seconds on top of the logo on the not remove the magnet yet. you can remove the magnet. The
zone anchor. zone anchor is ready for use.
www.sensolus.com | info@sensolus.com October 24, 2024 9:58 AM