Subscribe to Our Youtube Channel
Related Manuals for Acre comnet CWX52F4T48MP
Summary of Contents for Acre comnet CWX52F4T48MP
- Page 1 HARDWARE INSTALLATION AND OPERATION MANUAL CWX52F4T48MP 48-Port 10/100/1000M PoE+ and 4-Port 10G SFP+ L2+ Managed PoE Switch CWX52F4T48MP Hardware Manual | 1...
- Page 2 CWX52F4T48MP Hardware Manual | 2...
-
Page 3: Packet Contents
Hardware – Hardware Installation 1.1. Packet Contents Before you start to install this PoE+ Ethernet Switch, please verify your package and check if the following items are present: 1 × PoE Ethernet Switch • 1 × AC Power Cord • Accessory: 11”... -
Page 4: Hardware Description
Hardware – Hardware Installation 1.2. Hardware Description This section mainly describes the hardware of Full-Management PoE switch and gives a physical and functional overview of the switch. Front Panel The front panel of the switch consists of 48 10/100/1000 Base-TX RJ-45 ports and 4 10 Gigabit SFP+ ports. - Page 5 Hardware – Hardware Installation Brackets & Rack-mounting Installation The switch comes with 2 L shaped brackets & 8 screws, allowing you to fasten your switch to a 19-inch rack. The following sections will guide you to install L shape brackets on the switch and install the switch to a 19-inch rack.
- Page 6 Hardware – Hardware Installation Ethernet Cable Request The wiring cable types are as below: 10 Base-T: 2-pair UTP/STP CAT. 3, 4, 5 cable, EIA/TIA-568 100-ohm (Max. 100m) 100 Base-TX: 2-pair UTP/STP CAT. 5 cable, EIA/TIA-568 100-ohm (Max. 100m) 1000 Base-T: 4-pair UTP/STP CAT.
- Page 7 Hardware – Hardware Installation Uninstalling SFP Transceiver and Optical Cable Please follow the steps down below to uninstall SFP transceiver and optical cable on the switch. 1. Press and hold the latch on the optical fiber and pull the optical fiber out of the SFP transceiver, as shown in the figure down below.
Need help?
Do you have a question about the comnet CWX52F4T48MP and is the answer not in the manual?
Questions and answers