Hardware – Hardware Installation 1.1. Packet Contents Before you start to install this Ethernet Switch, please verify your package and check if the following items are present: 1 × PoE Ethernet Switch • 1 × AC Power Cord • Optional Accessory: 11” to 19” Rack-mount Kit for Rack Installation (Contact Sales) •...
Hardware – Hardware Installation 1.2. Hardware Description This section mainly describes the hardware of Full-Management PoE switch and gives a physical and functional overview of the switch. Front Panel The front panel of the Full-Management PoE switch consists of 24 10/100/1000 Base-TX RJ45 ports, 2 gigabit uplink SFP/RJ45 combo ports (Port 23/24), and 2 SFP gigabit ports.
Page 4
Hardware – Hardware Installation Brackets & Rack-mounting Installation The switch comes with 2 L shaped brackets & 8 screws, allowing you to fasten your switch to a 19-inch rack. The following sections will guide you to install L shape brackets on the switch and install the switch to a 19-inch rack.
Page 6
Hardware – Hardware Installation Uninstalling SFP Transceiver and Optical Cable Please follow the steps down below to uninstall SFP transceiver and optical cable on the switch. 1. Press and hold the latch on the optical fiber, and pull the optical fiber out of the SFP transceiver, as shown in the figure down below.
Need help?
Do you have a question about the comnet CWG26F4T22MP and is the answer not in the manual?
Questions and answers