MetalTech I-CISGR Operational Safety And Assembly Instructions page 2

OPERATIONAL SAFETY
en READ BEFORE BEGINNING ASSEMBLY.
FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH.
USER ASSUMES RISK OF PERSONAL INJURY BY FAILURE TO READ AND FOLLOW
MANUFACTURER'S SAFETY RULES AND ASSEMBLY INSTRUCTIONS, AND BY FAILURE TO
OBSERVE FEDERAL, PROVINCIAL/STATE AND MUNICIPAL CODES.
Do not use this equipment where contact may be made with power lines or other live electrical circuits.
A METAL CONDUCTS ELECTRICITY:
A OPERATION AND SAFETY
Always use this scaffold in conformity with local
or national legislation which applies.
Never stack more than two units.
Always use outriggers and guardrails when
stacking units.
Inspect before use. Do not use scaffold
if damaged or parts are missing.
Examine thoroughly to make sure unit is properly
set up.
Guardrails must be installed on all open sides
of a work platform where a person could fall from
a height of 6 ft (1.8 m) or more.
Always fasten the guardrails system to the structure
using locking pins or bolts.
Guardrails must be installed so that access door
swings inward over platform.
Always lock all access doors using door latches,
even if the scaffold is in use or not.
Securely lock all braces and platform before
each use.
There must be a minimum of two side braces
installed on each scaffold level and evenly spaced
throughout the scaffold. Lack of adequate bracing
could cause scaffold to collapse.
Always use outriggers secured to the structure
with the locking pins.
Always use casters locked to the structure
with the locking pins.
Do not climb unless all casters are in locked
position.
Erect to be plumb on firm and level surface.
This scaffold must be used on a firm surface
that is free of pits, debris, holes or obstructions.
Never place anything under or attach anything
to this scaffold to increase height or to adjust to
uneven surfaces.
Acids are corrosive and can seriously affect
strength. Do not expose this scaffold to corrosive
substances.
Keep scaffold free of debris and unnecessary
equipment.
Always keep body centered inside structure
of scaffold.
Remove or fasten all tools, material or equipment
before moving. Use extra caution when moving
to avoid tipping.
Never try moving this scaffold while
standing on it.
Never move a scaffold with a worker within.
Do not use powered devices to propel
this scaffold. Use extra caution near operating
machinery.
Do not use if the surface is not firm and level.
Do not use in inclement weather or high winds.
Maintain a firm grip while climbing.
Do not modify the scaffold or any of
its components.
Do not use the scaffold as a footbridge.
ASSEMBLY INSTRUCTIONS
Two types of fastener device can be —_— {a ©
supplied with this product: Lock pin Bolt with nut
@ Erect the scaffold (one or two frames high) by following the manufacturer instructions.
@ install the first guardrail panel by inserting two corner pegs into sockets in scaffold sides braces
and secure with lock pins or bolts supplied. Verify that the guardrail is firmly fastened to the platform
and it cannot be lifted.
Repeat with the second guardrail panel.
© Verify that the access doors swings inward over platform. Lock the access doors with the door latch.
LA AA N
À
BOX CONTENTS
QTY. DESCRIPTION
2 Guardrails
4 Lock pins OR bolts with nuts