Show Garp Timer - SMC Networks 8624T - annexe 1 Management Manual

C L
OMMAND INE
Note: Set GVRP timers on all Layer 2 devices connected in the same
Example
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#
Related Commands

show garp timer

show garp timer
Use this command to show the GARP timers for the selected interface.
Syntax
show garp timer [interface]
interface
• ethernet unit/port
• port-channel channel-id (Range: 1-6)
Default Setting
Shows all GARP timers.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show garp timer ethernet 1/1
Eth 1/ 1 GARP timer status:
Join timer: 20 centiseconds
Leave timer: 60 centiseconds
Leaveall timer: 1000 centiseconds
Console#
3-108
I
NTERFACE
network to the same values. Otherwise, GVRP will not operate
successfully.
- unit - This is device 1.
- port - Port number.