LAVABO Studio BTW 321111 Assembly Instructions

Studio BTW toilet
Art. No. 321111 & 321111MS
Front
ASSEMBLY INSTRUCTIONS
NOTE: All measurements for installation must be taken from the finished wall / floor
and toilet. Listed measurements are indicative only.
1. Mark for water inlet and drain pipe.
2. Mark and drill holes for floor mounting brackets from the supplied toilet (picture 2).
The floor mounting bracket can also be glued to the floor if there is a risk of hitting the underfloor
heating pipes.
Mark and fit the wall bracket, threaded rod and S-pipe, if the floor drain has an S-pipe (picture 3).
3. Place gasket on the pan and mount the cistern on the pan.
4. For S-pipe outlet - Prepare the floor drain according to picture 3 (S-pipe 140 mm - SW pipe min.
90 - max 140 mm). Mount the socket in the floor (not part of the delivery). Secure the S-pipe to the
wall using threaded rod and wall bracket. Connect water (3 options, right - / left side or from
behind). Push the toilet into the S-pipe.
5. For P-pipe outlet - Mount the P-pipe (not part of the delivery) in the wall (picture 5). Connect
water. Push the toilet into the P-pipe.
6. Check that the toilet bowl is level (picture 6) and that the cistern is level against the wall. Adjust if
necessary.
7. Flush and check for leaks.
S-pipe outlet
329003 INCLUDED
200
Tlf. +45 75 55 88 66 - E-mail: info@lavabo.dk - www.lavabo.dk
Side
SW 90°--pipe outlet
329004
max 160
min 90
Lavabo A/S - Neptunvej 17 - DK-6000 Kolding
Above
.
SW-pipe outlet
329001
max 250
min 160
180
P-pip putlet
329002