Table of Contents
Advertisement
In this page, you can configure the WAN interface of the device.
Click Add and the page as shown in the following figure appears:
The following table describes the parameters in this page.
Field
ATM PVC CONFIGURATION
VPI
VCI
Service Category
Peak Cell Rate
Sustainable Cell Rate
Maximum Burst Size
CONNECTION TYPE
Protocol
Virtual Path Identifier (VPI) is the virtual path between two points in an ATM network. Its
value range is from 0 to 255.
Virtual Channel Identifier (VCI) is the virtual channel between two points in an ATM
network. Its value range is from 32 to 65535 (0 to 31 is reserved for local management of
ATM traffic).
Select UBR with PCR, UBR without PCR, CBR, Non Real-time VBR, or Real-time VBR
from the drop-down list.
Set the maximum transmission rate of the cell in ATM transmission.
Set the minimum transmission rate of the cell in ATM transmission.
Set the maximum burst size of the cell in ATM transmission.
Select PPP over ATM (PPPoA), PPP over Ethernet (PPPoE), MAC Encryption Routing
(MER), IP over ATM (IPoA), or Bridging from the drop-down list.
Description
15
Advertisement
Table of Contents
