Page 1
VREC-H520DC DASH CAMERA Quick Start Guide Pioneer Electronics Australia Pty Ltd Unit 13, 135-155 Rooks Road, Vermont, Victoria, 3133, Australia Tel: (03) 9586-6300...
Page 2
Unit 13, 135-155 Rooks Road, Vermont, Victoria, 3133, Australia Tel :(03) 9586-6300 Do not ship your unit in for repair without contacting Pioneer first. Always produce the warranty card with serial number affixed on it. Units sent without a return authorization number or without serial number will be refused.
Precautions Information for users on collection and Warning disposal of old equipment and used batteries. • Do not install this product in your vehicle if its location or use would obstruct the driver’s clear view of (Symbol for Symbol example for the road or the operation of any equipment) batteries...
Page 4
Periodically inspect the door. this product. • Pioneer recommends that only authorized service company • personnel, who have special training and experience in mobile electronics, set up and install this product.
Page 5
Packaging Contents 1N Dash Camera [VREC-H520DC], 1N Power Adapter, 1N Power Cable, 1N Electrostatic Film, 1N Mount with adhesive, 1N Rear Camera, 1N Rear Camera Connecting Cable, 1N Quick Start Guide, 128GB SD card Product Appearance Rear camera connection Camera Lens...
Status Display The status display shows the operating status of this product. Date Recording Time Wi-Fi 10 Mic Rear Camera 11 Event Recording 12 Gallery ADAS 13 Settings Timelapse Speed System Indicator Display The operating status of this product is displayed with the system indicator. Illuminated Illuminated Blinking...
Page 7
During MENU screen display 9 Back 10 Go Previous / Up 11 Go Next / Down 12 Confirm During MENU screen display 13 Cancel 14 Confirm Inserting and Ejecting the microSD Card Turn OFF the power to this product when inserting and removing the microSD card. Inserting the microSD Card Ejecting the microSD Card Hold the top edge of the microSD card,...
Page 8
Always install this product in the specified installation position to ensure a safe field of view while driving and to achieve full performance from the product. Pioneer is not liable for any damages due to faulty or improper installation or use of the...
Page 9
Recommended Installation Position on Rear Windshield When installing the rear camera on the 2. Install the rear camera. inside of the rear window, installation Peel off the double-sided tape m a vehicle and in a position that release paper from the rear satisfies all of the following conditions is camera.
Page 10
Installing the Dash Camera 1. Clean the installation area of dirt • Route the power cable via A and oils using a clean cloth. column as shown below. A column Connecting cable 2. Install this product. (Included with the 2nd Peel off the double-sided tape This camera)
Direct connection with Vehicle Battery (Parking mode) Be sure to disconnect the y terminal of the vehicle’s battery before connecting the power cable. Parking mode can be enabled on this dash camera for which user have to purchase a Hardwire Kit and get it installed by a trained automobile technician. By using the power cable to draw power directly from the vehicle, this product can detect and record vehicle movement caused by vibration even when the vehicle’s ignitaun is turned OFF.
Page 12
Parking Mode provides added security by monitoring your vehicle when it is parked, and the engine is turned OFF. This mode is especially useful for capturing video footage of incidents such as theft, vandalism, or collisions that may occur while your vehicle is unattended. When activated, the dash camera enters a state of low power consumption and starts recording if vibration (detected by the G-sensor) or motion is detected.
Need help?
Do you have a question about the VREC-H520DC and is the answer not in the manual?
Questions and answers