SMC Networks 7004VBR User Manual page 20

Connect to the Internet
If Internet services are provided through a DSL or cable modem, use
unshielded or shielded twisted-pair Ethernet cable (Category 3 or greater)
with RJ-45 plugs to connect the broadband modem directly to the WAN
port on the Barricade. Use either straight-through or crossover cable
depending on the port type provided by the modem (see Appendix B).
6V 1A
ISP
(Primary)
Figure 2-3. Making WAN Connections
Note: When connecting to the WAN port, use 100-ohm Category 3, 4, or
5 shielded or unshielded twisted-pair cable with RJ-45 connectors
at both ends for all connections.
Connecting the Power Adapter
Plug the power adapter into the power socket on the Barricade, and the
other end into a power outlet. Check the indicator marked "Power" on the
front panel to be sure it is on. If the Power indicator is not lit, refer to
Troubleshooting in Appendix A.
WAN 4
Reset
3 1
2
LAN
DSL/Cable
Modem
I
NSTALLATION
2-7