R G M 6 0 0 0 M E T E R Q U I C K S TA R T G U I D E — Introduction User manual: https://www.electroind.com/ Installation of the RGM6000 meter must be products/shark-100-switchboard-power-meter/ performed only by qualified personnel who follow standard safety precautions during all procedures. Those personnel should have appropriate training and experience with high voltage devices.
M e c h a n i c a l i n s ta l l at i o n — Mechanical installation — 01 ANSI installation 96 mm square form — 02 DIN installation DIN mounting ANSI studs brackets 4.0"...
WYE with PTs, 3 phase, 4 wire 3 phase, 4 wire Delta direct, Delta with PTs, 3 phase, 3 wire 3 phase, 3 wire Other wiring configurations are available. See the RGM6000 meter user manual (see page 4 for the download link).
P r o g r a M s e t t i n g s — Program settings 4. Press the DOWN ARROW and then press the ENTER button. You will see the CT numerator setting screen (Ct-n). The current CT numerator is shown on the second line.
Page 8
R G M 6 0 0 0 M E T E R Q U I C K S TA R T G U I D E 7. Press the ENTER button to go to the PT 10. Press the ENTER button to go to the Connection numerator setting screen (Pt-n).
Page 9
Protocol setting screen (Prot). The meter’s current protocol is shown in the second and **the rgM6000 meter’s ethernet communication settings are the default settings of address 1, Baud rate 57.6 and Protocol Mod rtU. third lines. Press the DOWN ARROW to choose another communication protocol.
Page 10
— Factory initial default settings When the RGM6000 is powered up, for 10 seconds you can connect to the meter using the factory default settings (even if the device profile has been changed). After 10 seconds, the device profile reverts to the actual device profile in use.
r s 4 8 5 P o r t — RS485 port Follow these steps to connect to the meter 6. Click the profile button on the icon bar. via RS485: 1. Connect the meter to the PC, using an RS485 cable. 2.
Page 12
Any reproduction, to purchase orders, the agreed particulars disclosure to third parties or utilization shall prevail. ABB Inc. does not accept any of its contents – in whole or in parts – is responsibility whatsoever for potential forbidden without prior written consent errors or possible lack of information in of ABB Inc.
Need help?
Do you have a question about the RGM6000 and is the answer not in the manual?
Questions and answers