Save, Save & Restart, And Cancel Commands - SMC Networks 2585W-G User Manual

TCP/IP. TCP/IP-related settings.
Addressing. IP address settings for the SMC2585W-G to work with TCP/IP.
DHCP Server. Settings for the DHCP (Dynamic Host Configuration Protocol)
server on the SMC2585W-G.
IEEE 802.11. IEEE 802.11g-related settings.
Communication. Basic settings for the IEEE 802.11g interface of the
SMC2585W-G to work properly with wireless clients.
Security. Security settings for authenticating wireless users and encrypting wire-
less data.
Advanced. Advanced settings of the SMC2585W-G.
Packet Filters. Ethernet Type Filters, IP Protocol Filters, and TCP/UDP Port Fil-
ters settings.
Management. UPnP, System Log, and SNMP settings.
3.1.2. Save, Save & Restart, and Cancel Commands
There are three buttons - Save, Save & Restart, and Cancel - at the bottom of each page
Clicking Save stores the settings changes to the memory of the SMC2585W-G and brings
you back to the start page. Clicking Save & Restart stores the settings changes to the
memory of the SMC2585W-G and restarts the SMC2585W-G immediately for the settings to
take effect. Clicking Cancel discards any settings changes and brings you back to the start
page.
If you click Save, the start page will reflect the fact that the configuration settings have been
changed by showing two buttons—Restart and Cancel. In addition, changes are highlighted
in red. Clicking Cancel discards all the changes. Clicking Restart restarts the SMC2585W-G
for the new settings to take effect.
Fig. 16. Save, Save & Restart, and Cancel.
17