SMC Networks 1255TX-1 - annexe 1 Manual page 29

Step 3: The Device Status shows that the "This device is working properly". If there is any error
messages displayed here, you will need to click the SMC adapter and click [Remove]. Then reboot
the machine and go through the installation process again.
Windows NT
Step 1: Right-click the [Network] icon on your desktop and click [Properties].
Step 2: Verify that the SMC1255TX-1 adapter is listed in the [Adapters] section.
Step 3: Click [Start], click [Run] and type "eventvwr". This will bring up the entire System Log in
the Event Viewer. Make sure that there are no error messages regarding initializing the SMC adapter.
Step 4: Open your NT Diagnostics utility and make sure that the SMC adapter is listed. It will show
up as "FASTNIC_".
28