Switching On / Off; Volume Adjustment - VDO MS 5600 Manual

8

Switching on / off

The navigation computer is switched on and off together with the ignition.
Switch on the ignition.
:
As soon as the navigation system is operational, an instruction about using the system
appears in the display.
Read this instruction and confirm it by pressing the OK button on the remote control.
:
The Start menu appears.
Stand-by mode
You can switch the system into stand-by mode as follows:
Select "Stand-by" in the Start menu.
:
The display and the audible guidance messages are deactivated.
Press one of the cursor buttons 4, 6, 8, 2 or the OK button on the remote control
to exit stand-by mode again.
If an external loudspeaker is connected, you will continue to hear the audible mes-
sages in stand-by mode.
If you want to deactivate the audible messages, select "Stop guidance" before switch-
ing the system to stand-by mode.
If the navigation system is switched off in stand-by mode, it restarts in stand-by mode
when the ignition is switched on again.
Shut-down delay time
Immediately after switching off the ignition, the monitor is deactivated, but the navi-
gation computer remains active for a period that can be set. This has the advantage
that you can continue the directional guidance after a short stop (e.g. at the petrol
station), without the navigation computer having to calculate the route again.
The shut-down delay time can be set between 1 and 10 minutes in the "Settings –>
General settings –> Shut-down timer" menu. See Page 41.

Volume adjustment

You can set the volume of the audible guidance messages as follows:
Press the V button once or several times to increase the volume of the audible
messages.
Press the W button once or several times to decrease the volume of the audible
messages.
Operation