Eagle Group Director's Choice DCS-STURB Operation Manual

INSTRUCTION SHEET
#366755
Retain this manual
for future reference.
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY DAMAGE. SAVE YOUR BOX AND
ALL PACKING MATERIALS. YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED I MPROPERLY PACKED.
The unit is ready to operate as soon as it is plugged in and turned on. The thermostat has an "OFF" position and numbered from #1
through #7 (7 is the coldest). The unit has been pretested and set for proper operation with the thermostat set for 35˚ to 40˚F. Do not
block air discharge openings inside base of unit. A timer is installed in the system to shut the compressor off every 4 hours
(approximately 15 minutes) to eliminate ice build-up on the evaporator coil. Unit is supplied with power cord and NEMA plug. Refer to
the data plate located on the compressor compartment for the amperage and voltage information. Use a licensed electrician when
installing power source.
(1) This equipment is designed and sold for commercial use only by personnel trained and experienced in its operation and not sold for
consumer use in and around the home nor for use directly by the general public in food service locations.
(2) Prior to cleaning or maintenance, turn all switches "OFF" and unplug power cord from receptacle.
(3) The louvered panels may have sharp edges and could cause injury. DO NOT run fingers along edges and use gloves when cleaning.
(4) Wipe the cord and plug using a cloth with detergent and warm water. DO NOT use excessive water!
(5) Do not immerse unit in water.
(6) All repairs should be done by an authorized service center.
(7) Unit should be turned off when not in use. It is recommended that unit be disconnected from power supply by removing plug from
receptacle or shutting off power disconnect supply to the unit.
CAUTION: The fins of the condensing unit coils are sharp and may cause injury. Use care when cleaning, gloves should be worn.
It is very important for proper performance and condenser longevity to keep the condenser clean.
Every month:
1. DANGER: Disconnect electrical power to the freezer by turning master switch to "OFF" position and unplugging cooler from electrical
receptacle.
2. Remove louvered access panels from the condensing unit compartment.
3. Clean condenser by using a brush and vacuum cleaner to remove all dust and dirt. Thoroughly clean condenser. Wipe all surfaces of
the condensing unit using a soft cloth or sponge with a mild detergent. Rinse completely with warm water and then dry.
4. Re-install the louvered access panels.
WARNING: Refrigerant is under high pressure. DO NOT bend, kink, or damage any tubing or condensing unit coil.
Never clean metal with a chloride based products. Chlorides or improper cleaning could scar, mark and/or corrode metal. Use soapy warm
water to clean, rinse thoroughly to remove all residue. Do not use steel wool or abrasive products. Clean condenser coil regularly.
FAILURE TO MEET THESE CONDITIONS WILL VOID WARRANTY.
Laminate surfaces may be cleaned with warm water and mild soaps. Non-abrasive cleaners may also be used. Cleaning products containing
bleaching agents should not be used. Large quantities of these agents or extended periods of time can cause discoloration.
Refrigerated Base -
OPERATIONS MANUAL & INSTRUCTIONS
OPERATION FOR MECHANICAL REFRIGERATED BASE
MAINTENANCE/CLEANING FOR MECHANICAL REFRIGERATED BASE
MAINTENANCE FOR LAMINATES
Director's Choice
CAUTION
CAUTION:
CONDENSER CLEANING
®
Model #DCS-STURB
EG10083 Revised 10/23