Checking The Car Functions - VDO MS 3100 Owner's Manual

MOUNTING INSTRUCTIONS
Setting mounting angle
In order to ensure perfect functioning of the system, the computer must be adjusted
to the actual installation angle (e.g., in the dashboard).
1. Select the "Service" option from the "System settings" menu and enter the code.
Then select the "Mounting angle" option.
2. Depending upon the installation, set the angle to between - 10 and + 30 degrees.
The system does not differentiate between negative and positive angles. Thus, even
for a mounting angle of, e.g. - 10 degrees, set a value of "10" in the menu.

Checking the car functions

A
Only check safety functions when the car is standing still or driving at low speed!
Always carry out checks in open areas!
Check brake system, alarm system, lights, immobilizer, speedometer, trip computer,
radio (coding) and hi-fi stereo, clock.
Checking the navigation functions
Check the following functions when the car is stationary:
Remote control
Put remote control in the holder.
The keys on the remote control must light up.
GPS reception
Enter a destination and select "Guidance". Select info screen i3 "System info" and
check the number of received satellites. For sufficient positioning the number should
be between 4 and 8.
Calibration
Make a short test drive (approx. 10 minutes) on digitized streets for automatic
calibration. Change direction several times.
Cross different junctions and check the indicated position in info screen i1 "Car
position". If the indicated position matches the true car position, calibration is
finished.
Hotline
For answers and questions concerning the VDO Dayton Navigation System there is a
Hotline available in many countries.
G
0121 344 5400
Q
1 800 335 282 Toll Free or (03) 94503166
Subject to technical modifications and errors.
54