Viapoints; Entering Viapoints - VDO MS 3100 Owner's Manual

VIAPOINTS

Entering viapoints

If you like to pass by certain places on the way to your
destination address, you can store these as viapoints.
The navigation system then calculates the route in a
way that the viapoints are passed in the stored order
before reaching the destination address.
As soon as you reach a viapoint you hear "You have
arrived", then the navigation system starts route
planning for the next viapoint or to the final
destination.
Viapoints you did not reach or you do no longer wish to reach, can be deleted in the
Address Manager or in info screen i2. See page 26 or 35.
Select "Viapoint input" from the main control menu.
:
The "Viapoint input" menu is shown.
The following options are available in the "Viapoint input" menu:
New address
To enter the country, city, road, house number/ junction or a point of interest (special
destination) as a viapoint.
Load address
To recall an address previously stored in the address book as a viapoint.
Last destin.
To recall one of the 20 destinations last used for guidance as a viapoint.
Info on car pos.
To load a special facility which is located in vicinity of the current car position.
GPS co-ordinates
To enter a viapoint by use of the GPS co-ordinates (degrees of longitude and latitude).
Viapoint input procedure is exactly the same as entering a destination address.
24
Viapoint input
New address
Load address
Last destin.
Info on car pos.