Sam (Software Access Mode) - VDO CD 2202 User Manual

SAM (Software Access Mode)

It is possible to modify many of the set's default settings according to your preferences via 'SAM'.
• Press to enter the 'SAM' menu.
• Press or to select one of the options in the menu you want to modify.
• Press or to select the value/setting.
• Press to exit the 'SAM' menu.
The set automatically leaves this mode after 30 seconds if no key presses are made.
Option Value/Setting
( or ) ( or
TAVOL [1 to 31]
START [1 to 31]
MUTE [0 to 16]
NAV* [OFF, LOW, HIGH]
BEEP [0FF, 1, 2, 3, 4, 5]
SDVC * [OFF, 1, 2, 3, 4]
TEL/ [TEL OFF, MUTE HI,
HFREE MUTE LO, HFREE LO
HFREE HI]
CLK [ON, OFF]
CLOCK [RDSCLOCK,
MANCLOCK]
[CLOCKSET]
[12HCLOCK,
24HCLOCK]
* Depending on version
14
Usage
)
Select volume level of Traffic Announcement, News bulletins
and Alarm messages.
– Select the start-up volume when power on.
– After modification of the start-up volume, if the set is
switched off and on within 10 minutes, the start-up volume
reverts to the last used volume setting.
– After modification of the start-up volume, if the set is
switched off and on after more than 10 minutes later, the
start-up volume is the level defined in 'SAM'.
Select the mute level.
– Select 'OFF' if no navigation computer is connected to
the set.
– Select 'LOW' or 'HIGH' according to the navigation
computer's mute signal.
Select volume level of confirmation beeps.
Select the SDVC (Speed Dependent Volume Control)
compensation volume level (only when connected and
calibrated, see 'SDVC' in 'INSTALLATION' (page 5) and
'SPECIAL FUNCTIONS' (page 13)).
Level 1 gives a smaller increase while level 4 gives gives a
greater increase with respect to the car's speed.
– Select 'TEL OFF' if no car phone is connected to
the set.
– Select 'MUTE LO' or 'MUTE HI' (according to phone type)
to automatically interrupt the set's sound output when
using your car phone.
– Select 'HFREE LO' or 'HFREE HI' (according to phone
type) if your phone provides a loudspeaker connection.
Select 'ON' to activate CLOCK feature.
Select 'RDSCLOCK' to activate RDS clock or "MANCLOCK'
to set clock manually.
If 'MANCLOCK' selected; set the time.
digit,
Select desired clock format.
to adjust the minute digit.
to adjust the hour