How To Assemble The Toy For Use In The Rocker Play Mode; How To Assemble The Toy For Use In The Push ‘N’ Go Play Mode - Chicco QUATTRO Manual

• Do not try recharging unchargeable batteries: they may explode.
• The use of rechargeable batteries is not recommended as they may decrease the toy's functionality.
• When using rechargeable batteries, remove them from the toy before recharging and recharge only
under adult supervision.
• The toy is not designed to operate on Lithium replaceable batteries.

HOW TO ASSEMBLE THE TOY FOR USE IN THE ROCKER PLAY MODE

• Fit the two armrests, first the right armrest (facing the toy from the front) and then the left armrest.
Ensure that the front ring of the right armrest is placed under the front ring of the left armrest, as
shown in diagram 6. Insert the three screws (diag. 1-I), and screw them tightly to the end. The two
identical, longer screws should be screwed into the rear housings (diag. 6-A), while the shorter screw
should be screwed into the front housing (diag. 6-B). It is recommended to carry out this operation
with a coin, which should be kept out of reach of children after use.
• Fit weighted bases as follows. Turn the toy on one side, then proceed in the following order: fit the
weighted bases into the appropriate housings; lock the weighted bases to the car body using the
screws (indicated by an L in diag. 1), ensuring that the left and right sides are fitted correctly into posi-
tion (see diag. 7). Screw the screws tightly. It is recommended to carry out this operation with a coin,
which should be kept out of reach of children after use.
• Fit the activity centre onto the steering wheel, exercising simply a slight pressure (diag. 8).
• The toy is ready to be used in the ROCKER PLAY mode (diag. 9).
Warning!
Remember to fasten the safety belts, and to adjust them to the size of the child's body.
HOW TO ASSEMBLE THE TOY FOR USE IN THE PUSH 'N' GO PLAY MODE
• Remove the weighted bases, as shown in diagram 10. Unscrew the L screws, remove the bases and
insert the footrest into its appropriate housing (diag. 11). Screw the screws tightly to the end.
• Fit the parent push handle, inserting it as shown in diagram 12. Fit the tubes into the housings of the
handle, until a click is heard, indicating that they are correctly fitted into position (the tubes are sym-
metrical, therefore, they can be fitted into whichever housing). Ensure the tubes are safely fitted into
position, pulling them in the opposite direction of the handle.
• Fit the lower part of the tubes (the end opposite to the handle) into the correct holes, located
in the rear yellow handle, opening the sliding closures by means of the buttons located under
the handle (diag. 13). When fitting the tubes, it is necessary to push back their locking pins, and
then insert the tubes to the end, until a click is heard, indicating that they are correctly locked
into position. Ensure that the tubes are locked correctly, checking that the position of the tubes'
locking pins corresponds to the position shown in diagram 14, and by pulling the handle in an
upward direction.
• The toy is now ready to be used in the PUSH 'N' GO PLAY MODE (diag. 15).
Warning!
• If the child is still not able to sit on its own, it is recommended to hold the toy by the specific handle
to avoid any overturning.
• When the child is sitting in the toy, do not use the handle to lift the toy, avoid obstacles or to hold the
toy on slopes.
14