How To Assemble The Toy; Inserting And Removing Replaceable Batteries - Chicco QUATTRO Manual

D. - Backrest /handy support for children
E. - Seat
F. - Left and right safety armrests
G. - Left and right retractable footrest
H. - Left and right stability-weighted bases
I. - No. 3 screws for fitting the armrests (2 rear and 1 front)
L. - No. 2 screws for fitting the footrest and weighted bases
M. - Parent handle for pushing the toy, comprising handle and two tubes
N. - Safety belt

HOW TO ASSEMBLE THE TOY

After purchasing this toy, carry out the following assembly operations, regardless of the play mode desired:
• Fit the steering wheel, as shown in diagram 2. For the correct assembly and use of the steering wheel,
fit the component only as shown in the diagram. Push the steering wheel in a downward direction,
until a click is heard, indicating that it is correctly fitted into position. Check that the steering wheel is
safely locked into position, by pulling it towards you.
• Fit the backrest, as shown in diagram 3. Push the backrest in a downward direction, until a click is
heard, indicating that it is correctly locked into position. Check that the backrest is safely locked into
position, by pulling it towards you.
• To fit the safety belt, slide it from the rear of the backrest through the openings, until the hook located
at the end of the safety belt locks inside the hole. Pull the belt until a click is heard, indicating that it
is locked into position (diag. 3).
• To remove the safety belt, press on the tab, located at the end of the safety belt. This will release the
tab and allow you to slide the belt from the hole located on the seat.
• Fit the seat as shown in diagram 4, locking the front part to the devices located in the car body (diag.
4-A), and maintaining the rear part raised, until it is safely locked into position. At the end of the opera-
tion, position the rear part of the seat as shown in diagram 4-B.
• Fit the batteries in the activity centre (diag. 5), following the instructions provided below:

INSERTING AND REMOVING REPLACEABLE BATTERIES

• Battery replacement must always be performed on behalf of an adult.
• To replace batteries: loosen the screw on the battery compartment hatch (fig. A-2) with a screwdriver,
remove the hatch, remove flat batteries from the battery compartment, insert new batteries making
sure the polarity is correct (as indicated on the product), replace the hatch and tighten the screw
firmly.
• Use same or equivalent alkaline batteries as those recommended to operate this product.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Keep batteries or other tools out of children's reach.
• Do not short circuit feed clamps.
• Always remove flat batteries from the product to avoid damages to the product by possible leakage.
• Always remove batteries in case the product is not used for long periods.
• Remove batteries from the product before disposal.
• Do not throw flat batteries into fire or disperse in the environment, but dispose through separate
refuse collection.
• Should batteries leak, replace them immediately after cleaning the battery compartment and wash
hands thoroughly in case they have come into contact with the leaking liquid.
13