mxr Clone Looper M303G1 Manual

M303

Clone Looper Pedal

™

Whether you're practicing at home, captivating

audiences with improvisational compositions

onstage, or weaving intricate sonic tapestries in the

studio, the Clone Looper Pedal has you covered.

Packed into a standard MXR housing that's built like

a tank, it's easier to use and delivers higher fidelity

signal reproduction than any other looper of its

type—hands down.

jimdunlop.com/m303

Table of Contents

Need help?

Do you have a question about the Clone Looper M303G1 and is the answer not in the manual?

Page 1 Clone Looper Pedal has you covered. Packed into a standard MXR housing that’s built like a tank, it’s easier to use and delivers higher fidelity signal reproduction than any other looper of its type—hands down.
Page 2: External Controls
External Controls 1 REC/DUB footswitch controls loop recording and clear loop quickly functions 2 VOLUME knob controls output level, loop speed, loop direction and clear loop quietly functions 3 PLAY/STOP footswitch controls loop playback and undo/redo functions 4 CTR jack allows tap switch to control loop speed, loop direction, and clear loop quietly functions 5 EXP jack allows expression pedal to set...
Page 3: Basic Operation
Basic Operation 1. Run a cable from your guitar to the M303’s INPUT jack 6. Rotate the VOLUME knob clockwise to raise the loop’s and run another cable from the M303’s OUTPUT jack to output level or counterclockwise to decrease it. your amplifier.
Page 4: Advanced Operation
VOLUME knob past 12 o’clock twice. USE A TAP SWITCH TO PLAY LOOP ONCE Connect an MXR Tap Tempo Switch to the M303’s EXP jack with a mono cable. To initiate Play Loop Once mode, tap the switch.
Page 5: Specifications
Specifications Input Impedance 1MΩ Output Impedance 100 Ω Maximum Intput Level +5dBV Maximum Output Level +5dBV Frequency Response 20 Hz to 20 kHz Noise Floor -97 dBV Sampling Rate 44.1 kHz Current Draw 225 mA Power Supply 9 volts DC M303 | Clone Looper ™...

Clone looper m303