ENGLISH
CONTENTS
• 56413 Rechargeable 2-Color LED
Flashlight
• Holster
• 6" USB-C cable
• This instruction manual
GENERAL SPECIFICATIONS
• Operating Altitude: 6562 ft. (2000 m)
• Operating Temperature:
32°F to 104°F (0°C to 40°C)
• Storage Temperature:
-4°F to 113°F (-20°C to 45°C)
• Charging Temperature:
32°F to 95°F (0°C to 35°C)
• Relative Humidity: <85% non-condensing
• Battery Type:
Internal, 18650 Lithium Ion, 3.6V / 2600mAh
• Charging Requirements:
Maximum 5V DC, Maximum 2.4A
• Lighting Mode Specifications:
MODE
LUMENS HOURS*
BOOST
On
1000
(SPOT + FLOOD)
High
800
SPOTLIGHT
Low
400
Strobe
95
High
640
FLOODLIGHT
Medium
450
Eco
25
Solid
4
RED LIGHT
Strobe
4
*NOTE: Listed runtimes are based on fully-charged
battery and continuous use. Frequent switching
on and off will result in battery drain and reduced
runtime.
• Drop Protection: 9.8' (3 m)
• Ingress Protection Rating: IP64
• Certifications:
CE, UKCA, REACH, RoHS, DOE/CEC, NRCan
Specifications subject to change.
WARNINGS
Read, understand, and follow these
instructions to ensure safe operation.
Failure to observe these warnings can result
in risk of fire, electric shock, serious injury
and/or property damage.
• The lens gets very hot during use. To reduce the
risk of burns, DO NOT touch hot lens.
• To reduce the risk of fire, keep away from
combustible materials while in operation. DO NOT
cover lens.
• DO NOT use the product if it is damaged or
modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire,
explosion, or injury.
• Risk of fire and burns. DO NOT open, crush,
heat above specified maximum temperature or
incinerate. Prolonged exposure to direct sunlight
can result in elevated temperatures
• DO NOT immerse in water or other liquids
Properly seal the charging port cover to achieve
specified water & foreign object ingress
protection. Keep seal free of dirt, oil, sand, or
other material that interferes with proper sealing.
Failure to do so can result in risk of fire or electric
shock.
• DO NOT open the charging port cover if wet or in
a wet environment. Thoroughly dry the unit and
the seal around water-resistant cover completely
before opening water resistant cover.
• DO NOT subject to impacts or drops greater than
9.8 ft. (3 m).
Drops larger than this may not show signs of
damage, but internal components may have been
compromised. It is advisable to replace the unit if
any such severe events occur.
• To reduce the risk of injury, DO NOT stare at
operating lamp. Serious eye injury could occur.
• DO NOT attempt to repair the product or charging
cable. There are no user-serviceable parts.
56413-1390414ART - WEB`.indd 1
56413-1390414ART - WEB`.indd 1
FEATURE DETAILS (FIG. A)
1 LED light
2 Battery level indicator
3 USB-C charging port
4 Pocket clip
5 Power button
6 Magnet
7 USB-C charging cable
SYMBOLS ON PRODUCT
Warning or Caution
Risk of Electrical Shock
Hot Surface - Do Not Touch
Do Not Stare at Operating Lamp:
Visible Radiation
Read Instructions
Conformité Européenne. Conforms with
European Economic Area directives
UKCA - United Kingdom Conformity
Assessment
4
Direct Current (DC)
7
OPERATING INSTRUCTIONS
11
CHARGING BATTERY
50
Fully charge before use. First-time charge
6
should be at least 6 hours. To access the
10
charging port, twist the collar just below
32
the flashlight head (after charging, return
48
the collar to the original position to protect
96
the charging port). Connect USB-C cable
connection to headlamp, plug the other end
of cable into USB port, or AC adapter (not
included). USB adapter/power supply should
not exceed the specified charging voltage and
current (Max 5.0V DC, Max 2.4A).
BATTERY LEVEL INDICATOR
The Battery Level Indicator
illuminate when connected to charger and
disconnected from charger to show battery
level.
LEGEND
Not Illuminated
Green
Yellow
TABLE 1 - CHARGING STATUS
LED
Status
% Charged
Blinking red
0% to 25% charged
Blinking yellow
26% to 49% charged
Blinking green
50% to 99% charged
Solid green
100% charged
TABLE 2 - CHARGE REMAINING
LED
Status
Remaining Charge
Solid green
50% to 100% charge remaining
Solid yellow
26% to 49% charge remaining
Solid red
16% to 25% charge remaining
Blinking red
1% to 15% charge remaining
Not illuminated
0% charge remaining
NOTE: When the battery is fully discharged,
the Battery Level Indicator
illuminate immediately when charging cable
is connected.
POWER ON/OFF AND MODE SELECTION
• Press and release the Power Button
power unit on.
• Once powered on, press and hold the
Power Button
to toggle through
5
the available modes (see GENERAL
SPECIFICATIONS section).
• Once the desired mode is entered, press
and release the Power Button
seconds to reduce the brightness.
• After 5 seconds in any mode, press and
release the Power Button
NOTE: The unit will power on in the same
mode that was in use when last powered
off.
OPERATING INSTRUCTIONS
BATTERY INTERNAL TEMPERATURE
PROTECTION INDICATION
If the temperature of the product falls
outside the ranges defined in the GENERAL
SPECIFICATIONS section, the Battery Level
Indicator 2 will rapidly blink red, and the
battery will shut down and stop charging.
Functionality will resume when product's
temperature is back within proper ranges.
MOUNTING / CARRYING / STORAGE
OPTIONS
• The magnet
6
mounted onto any ferrous surface.
• The pocket clip
unscrewing the endcap.
• The holster can be attached to a belt, and
the flashlight stored inside.
TROUBLESHOOTING
56413 will NOT recharge if:
• the cable is not properly connected to
charger output or battery input. Check
connection;
• the charging cable is damaged. Replace
with equivalent cable; or
• the charging port or device is not able to
supply the minimum voltage and current
for charging. Connect to appropriate
charging source.
MAINTENANCE
CLEANING: Disconnect the device from all power
sources and devices prior to cleaning. Use clean,
dry, soft, lint-free cloth to wipe down the entire unit.
DO NOT use abrasive cleaners or solvents.
STORAGE: If storing for more than 1 month,
charge completely before storage, and recharge
approximately every 3 months to avoid full
discharge. Store in cool temperatures, mild
will
2
humidity, and away from direct sunlight (See
GENERAL SPECIFICATIONS). Leaving the unit in
a vehicle or other confined spaces in extreme hot
temperatures can lead to decrease in service life,
overheating, or fire. Extreme cold temperatures
Red
Blinking
below the specified storage range can also harm
performance and service life. Keep away from
corrosive chemicals and gases. After taking out of
storage, inspect visually to make sure device and all
accessories look satisfactory. Allow unit to return to
ambient conditions before recharging or charging
other devices.
RECHARGING: If the flashlight is to be left
unused for an extended period of time,
charge to approximately 50% (Green LED)
before storing, and recharge periodically
during storage to maintain battery's charging
capacity.
FCC AND IC COMPLIANCE
See this product's page at www.kleintools.
com for FCC compliance information. Canada
may not
2
ICES-003 (B) / NMB-003 (B)
WARRANTY
www.kleintools.com/warranty
DISPOSAL / RECYCLE
to
5
Do not place equipment and its accessories
in the trash. Items must be properly disposed
of in accordance with local regulations.
Please see www.epa.gov/recycle for
additional information.
CUSTOMER SERVICE
within 5
5
KLEIN TOOLS, INC.
450 Bond Street Lincolnshire, IL 60069
to power off.
1-800-553-4676
5
customerservice@kleintools.com
www.kleintools.com
Rechargeable 2-Color LED Flashlight with Holster
on the endcap can be
can be removed by
4
FIG. A
56413
INSTRUCTIONS
1
2
3
4
5
6
7
BASED ON 1390414 Rev 10/24 C
12/5/2024 2:54:09 PM
12/5/2024 2:54:09 PM
Need help?
Do you have a question about the 56413 and is the answer not in the manual?
Questions and answers