Advertisement
The Shiatsu+ Massaging Cushion comes with a screw located on the back of the unit to protect the massage mechanism during shipment, which must be removed before the first use to allow the unit to function properly. Use the provided allen wrench. Then, properly dispose of the screw.
The actual product materials and fabrics may vary from the picture shown.
Failure to remove screw may cause permanent damage to the massage cushion.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Untie cord strap, extend cord and insert plug into 120-volt household electrical outlet to power unit.
Attach the cushion to most chairs for a luxurious massage as you read, rest or even work. See below for instructions on the use of the hand control.
NOTE: There is a 15-minute auto shut off on the unit for your safety.
Strapping System
The Shiatsu+ Massaging Cushion incorporates a unique strapping system which allows you to fasten it to almost any chair. Just slip the straps over the seat or chair and adjust fastening straps to secure.
Your massager won't slip or slide away.
To avoid pinching do not lean on the dual massage mechanism in the cushion when adjusting your body position.
Do not jam or force any part of your body in the moving massage mechanism.
Do Not use Spot Shiatsu with heat for the back in one area for more than 3 minutes.
Please note: Not recommended for use on wooden surfaces as the zipper may damage the wood. Caution is also recommended when using on upholstered furniture.
NOTE: Only gentle force should be exerted against the unit in order to eliminate any/all risk of injury. You may soften massage force by placing a towel between yourself and the unit.
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects which might cut or puncture the fabric surface. To avoid breakage, do not wrap the power cord around the unit. Do not hang the unit by the hand control cord.
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly damp sponge. Never allow water or any other liquids to come into contact with the unit.
Please note:
Not recommended for use on wooden surfaces as the zipper may damage the wood. Caution is also recommended when using on upholstered furniture.
NOTE: Only gentle force should be exerted against the unit in order to eliminate any/all risk of injury. You may soften massage force by placing a towel between yourself and the unit.
Make sure the cushion is unplugged and the cord is properly secured in the pocket between the cushion and seat. With cushion sitting upright in the chair, fold the flaps on the sides of the cushion in toward the center and hold them there (see Fig. 1). Next, fold the flaps on the sides of seat in toward the center (see Fig. 2). Fold the seat up toward the cushion (see Fig. 3). Secure the seat to the cushion with the elastic strap on the back of the cushion (see Fig. 3).
Make sure the cushion is unplugged and the cord is properly secured in the pocket between the cushion and seat. With cushion sitting upright in the chair, remove the bag from the compartment on the cushion (see Fig. A). Unzip the bag and slide it over the cushion from the top down (see Fig. B). Zip the bag and carry the cushion by the handles on the side of the bag (see Fig. C).
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
TO REDUCE THE RISK OF ELECTROCUTION:
TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE OR INJURY TO PERSONS:
SAVE THESE INSTRUCTIONS
All servicing of this massager must be performed by authorized HoMedics service personnel only.
Please read all instructions carefully before operating.
To obtain warranty service on your HoMedics product, mail the product and your dated sales receipt (as proof of purchase), postpaid, to the following address:
HoMedics Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI 48390
Mail To:
HoMedics
Service Center, Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390
e-mail:
cservice@homedics.com
Monday - Friday
8:30am - 5:00pm (EST)
1.800.466.3342
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the MCS-350H and is the answer not in the manual?
Questions and answers