Advertisement
The actual product materials and fabrics may vary from the picture shown.
The Cushion comes with a screw located on the back of the unit to protect the massage mechanism during shipment, which must be removed before the first use to allow the unit to function properly. Use the provided allen wrench. Then, properly dispose of the screw.
Failure to remove screw may cause permanent damage to the massage cushion.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
The Cushion incorporates a unique strapping system which allows you to fasten it to almost any chair. Just slip the straps over the seat or chair and adjust fastening straps to secure. Your massager won't slip or slide away.
Note:
Not recommended for use on wooden surfaces as the zipper may damage the wood. Caution is also recommended when using on upholstered furniture.
Note:
Only gentle force should be exerted against the unit in order to eliminate any/all risk of injury. You may soften massage force by placing a towel between yourself and the unit.
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects which might cut or puncture the fabric surface. To avoid breakage, do not wrap the power cord around the unit. Do not hang the unit by the hand control cord.
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly damp sponge. Never allow water or any other liquids to come into contact with the unit.
Massage Cushion with heat
Demo Button
For a brief demonstration of the features of the Massage Cushion, press the Demo button. The unit will briefly go through each function. Once completed, the unit automatically turns off. The L.E.D. light will blink to indicate active function.
Massage Zones
Choose from 3 preset programs where the Shiatsu massage travels up and down in a specific area of the back – full, upper and lower. To select a program, simply press the button and the L.E.D. will illuminate. To deselect, press the button again or press another button.
Heat Button
For soothing heat, when massage is on, simply press the heat button and the corresponding red L.E.D. light will illuminate. To deselect, press the button again and the corresponding L.E.D. light will turn off. For your safety, heat cannot be turned on if no massage program is selected.
Power Button
To turn on the massage functions, first press the POWER button. The L.E.D. indicator will illuminate and confirm your selection. To turn off the massage functions, simply press the button again. The L.E.D. indicator will blink while the massage mechanism returns to its lowest point and then will turn off.
Air Programs
Choose from 3 preset intensity levels where the Air massage will use gentle compression to massage your sides (Fig. 1).
Fig. 1
To activate the Air massage, simply press the AIR MASSAGE button and the corresponding L.E.D. light will illuminate. The Air massage air bags will inflate at low intensity. To change the air intensity level, press either the + or – buttons. The air program will move to the desired intensity level. While the air intensity is being adjusted, the corresponding L.E.D. light will blink. The light will change to steady illumination when the desired intensity level is reached. To turn the Air massage off, press the AIR MASSAGE button again. The air bags will deflate and turn off.
Shiatsu Massage
Shiatsu is a deep kneading massage.
Air Massage
Air massage is a gentle midsection compression massage.
NOTE: There is a 15-minute auto shut off on the unit for your safety.
NOTE: The moving massage mechanism always "parks" or finishes in its lowest position. It will continue to this position after the power has been turned off. If the electrical supply is interrupted, when power is restored, the mechanism will "park" or move to its lowest position.
Email: cservice@homedics.com
1.800.466.3342
Monday – Friday
8:30am – 7:00pm (EST )
LIMITED TWO YEAR WARRANTY (Valid in USA only)
To obtain warranty service on your HoMedics product, contact a consumer relations representative by telephone at 1-800-466-3342 for assistance. Please make sure to have the model number of the product available.
For more information regarding our product line in the USA, please visit: www.homedics.com
REGISTER YOUR PRODUCT AT: www.homedics.com/register
Your valuable input regarding this product will help us create the products you will want in the future.
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
TO REDUCE THE RISK OF ELECTRIC SHOCK:
TO REDUCE THE RISK OF BURNS, ELECTRIC SHOCK, FIRE OR INJURY TO PERSONS:
All servicing of this massager must be performed by authorized HoMedics service personnel only.
SAVE THESE INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING.
To avoid pinching do not lean on the massage mechanism in the cushion when adjusting your body position.
Do not jam or force any part of your body in the moving massage mechanism.
Note: There is a 15-minute auto shut off on the unit for your safety.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the Destress MCS-775HTL and is the answer not in the manual?
Questions and answers