Pairing It With Your Phone - Jabra BT2010 - ANNEXE 746 Manual

7. Pairing it with your phone

Headsets are connected to phones using a procedure called 'pairing' . By
following a few simple steps, a phone can be paired with a headset in a
matter of minutes. ( See fig 3)
. Put the headset in pairing mode
• When you turn on your Jabra BT2010 for the first time, the headset will
automatically start up on pairing mode – i.e. it is discoverable for your
phone. When the headset is in pairing mode the LED is constantly lit.
. Set your Bluetooth phone to 'discover' the Jabra BT00
• Follow your phone's instruction guide. First make sure that Bluetooth is
activated on your mobile phone. Then set your phone to discover the
headset. This usually involves going to a 'setup, ' 'connect' or 'Bluetooth'
menu on your phone and selecting the option to 'discover' or 'add' a
Bluetooth device.*
. Your phone will find the Jabra BT00
• Your phone will find the headset under name "Bluetooth headset".
Your phone then asks if you want to pair with the headset. Accept by
pressing 'Yes' or 'OK' on the phone and confirm with the passkey or PIN
= 0000 ( zeros). Your phone will confirm when pairing is complete.
fig 3

In case of unsuccessful pairing, put the Jabra BT2010 into pairing mode
manually. Make sure the headset is off. Press and hold the answer/end
button for approximately  seconds until the LED has a constant light.The
LED will flash before the light is constant – keep holding down the button
until light is constant.