Getting Ready To Mend - Singer TINY TAYLOR TT700 Instruction Manual

GETTING READY TO MEND

1. Assemble spool holder by snapping spool
pin into spool stand.
2. Slide spool stand into its holder on rear left
of machine, until it snaps firmly into place.
Then install spool cap on spool pin
Table of Contents
TT700
3. Make sure that power switch is in the ON
position. Plug in foot switch and AC
adapter plugs.
4. Remove red-handled seam ripper/thread
trimmer and needle threader from
accessory drawer.
7
Previous Page | Next Page