Raising The Bobbin Thread - Singer TINY TAYLOR TT700 Instruction Manual

RAISING THE BOBBIN THREAD

1. Hold top (needle) thread and
wheel toward you
lowest and then its highest point.
Raise the presser foot using the presser
bar lifter.
Table of Contents
TT700
turn hand-
until needle goes to its
2. Gently pull top (needle) thread until lower
(bobbin) thread comes up in form of a
loop.
3. Use the flat side of seam ripper/thread
trimmer to open up bobbin thread loop
until end is visible.
4. Pull both thread tails straight back under
presser foot.
5. Replace see-though bobbin cover by
sliding it back into place.
14
Previous Page | Next Page