To Oil Machine - Singer NO. 27 Instructions For Using Manual

To ensure easy running the machine requires to be oiled so that all moving parts in contact
are covered with a film of oil. These should never be allowed to become dry.
If used constantly, the machine should be oiled daily, while with moderate use, an occasional
oiling is sufficient. A drop of oil applied at the points indicated by arrows in Figs. 14 and 15 is
sufficient. The small plate in front of the machine and the larger plate at the back should both
be turned up and oil applied to the parts exposed. It is important that oil be applied to point
"A," Fig. 14, when the take-up lever (2, Fig. 5) is at its lowest, and a little oil rubbed over the
surface of the shuttle race. There are also two holes in the hand attachment to which oil
should be applied occasionally. When oiling, insert the oil can spout well into the holes.
27 & 28
To Oil the Machine
FIG. 14
16