Advertisement
Quick Links
HEP55
(VB00025 model)
INSTALLATION BY A PROFESSIONAL
IS STRONGLY RECOMMENDED
Stove Builder International inc.
https://www.occanada.com/ca/fr/
CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION
INSPECTION REQUIREMENTS IN YOUR AREA.
PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET FUEL-
BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
READ AND KEEP THIS MANUAL FOR REFERENCE
Advertisement
Related Manuals for Ventis HEP55
Summary of Contents for Ventis HEP55
- Page 1 HEP55 (VB00025 model) INSTALLATION BY A PROFESSIONAL IS STRONGLY RECOMMENDED Stove Builder International inc. https://www.occanada.com/ca/fr/ CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA. PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET FUEL- BURNING ROOM HEATER.
- Page 2 1. SAFETY INFORMATION WARNING THIS STOVE IS MOBILE HOME APPROVED AND REQUIRES INSTALLATION OF A FRESH AIR KIT, SOLD SEPARATELY. THE STOVE MUST BE ATTACHED TO THE STRUCTURE OF THE MOBILE HOME AND THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, If this appliance is not properly installed, WALL, AND CEILING / ROOF MUST BE combustible materials near it may overheat.
- Page 3 NOTICE WARNING DO NOT INSTALL IN ANY FIREPLACE. CAUTION MAINTAIN PROPER VENTILATION. IT IS IMPORTANT THAT ADEQUATE OXYGEN IS NOTICE BEING SUPPLIED TO THE FIRE FOR PROPER COMBUSTION. DURING WINTER SEASON, MAKE SURE THAT THE FRESH AIR INTAKE IS FREE OF ANY ICE, SNOW, ETC., AS THIS WILL STARVE THE FIRE OF AIR AND PREVENT THE PROPER OPERATION OF THE STOVE.
- Page 4 1. SAFETY INFORMATION ................2 2. GENERAL FEATURES .................. 5 2.1 OVERALL DIMENSIONS (E).....................6 2.2 REGULATIONS COVERING PELLET STOVE INSTALLATION ........6 2.3 CERTIFICATION LABEL LOCATION ................6 3. CLEARANCES TO COMBUSTIBLE MATERIALS ........7 3.1 CLEARANCES TO COMBUSTIBLES MATERIALS, WALLS AND CEILING ....7 3.2 FLOOR PROTECTION ......................8 4.
- Page 5 2. GENERAL FEATURES Recommended chimney diameter Flue outlet diameter Type of chimney Approved for alcove installation Approved for mobile home installation ‡ Shipping weight (without option) Appliance weight (without option) Particulate emission standard USA standard (safety) Canadian standard (safety) Electrical requirements Mobile home (Canada) or manufactured home (USA): The US department of Housing and Urban Development describes...
- Page 6 2.2 REGULATIONS COVERING PELLET 2.1 OVERALL DIMENSIONS (VB00025) STOVE INSTALLATION 2.3 CERTIFICATION LABEL LOCATION CAUTION DO NOT USE MAKESHIFT MATERIALS OR MAKE ANY COMPROMISES WHEN INSTALLING THIS STOVE.
- Page 7 3. CLEARANCES TO COMBUSTIBLE MATERIALS RECOMMENDED CLEARANCES FOR MAINTENANCE CANADA WARNING NO PART OF THE PELLET VENT SYSTEM MAY BE LOCATED CLOSER TO COMBUSTIBLES THAN THE MINIMUM CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. WARNING NOTICE NO PART OF THE STOVE MAY BE LOCATED also valid for an CLOSER TO COMBUSTIBLES THAN THE alcove installation.
- Page 8 FLOOR PROTECTION CANADA** CAUTION STOVE MUST PLACED CONTINUOUS (GROUTED JOINTS) NONCOMBUSTIBLE MATERIAL SUCH AS CERAMIC TILE*, CEMENT BOARD, BRICK, MINIMUM CLEARANCES MILLBOARD OR EQUIVALENT, OR ANY OTHER CANADA APPROVED OR LISTED MATERIAL SUITED FOR FLOOR PROTECTION. *Any type of tile will require a continuous non combustible sheet beneath to prevent the possibility of embers falling through to the combustible fl...
- Page 9 4. VENTING SYSTEM 4.2 RECOMMANDATIONS CAUTION CONNECT THIS STOVE ONLY TO A LISTED PELLET EXHAUST VENTING SYSTEM FOR USE WITH SOLID FUEL OR TO A LINED CHIMNEY CONFORMING TO NATIONAL AND LOCAL BUILDING CODES. CAUTION DO NOT CONNECT THIS STOVE TO ANY OTHER EXISTING VENTING SYSTEM SERVING ANOTHER APPLIANCE.
- Page 10 CAUTION TO REDUCE THE RISK OF SMOKE SPILLAGE THERE SHOULD ALWAYS BE AT LEAST ONE FOOT OF VERTICAL RISE FOR EACH FOOT OF HORIZONTAL RUN. IN ALL CASES, AT LEAST 3 FEET OF VERTICAL RISE IS NEEDED. Since the total EVL is less than 15 feet, the re- WARNING commended exhaust venting diameter is 3".
- Page 11 4.4 TERMINATION LOCATION CANADA Min. Description Clearances United-States...
- Page 12 4.5 DIRECT VENT SYSTEM In Canada In the Unites States : 4.6 INSTALLATION CONFIGURATION...
- Page 13 NOTICE NOTICE NOTICE...
- Page 14 INSTALLING THE OPTIONAL HOPPER EXTENSION...
- Page 15 7.1 THERMOSTAT LOCATION 6. MOBILE HOME INSTALLATION NOTICE NOTICE 7. INSTALLING A THERMOSTAT NOTICE...
- Page 16 7.2 WIRED THERMOSTAT 7.3 WIRELESS THERMOSTAT 8. COMBUSTION AIR SUPPLY NOTICE...
- Page 17 8.1 SOURCES OF OUTSIDE COMBUSTION CAUTION IT IS FORBIDDEN TO DRAW COMBUSTION AIR FROM A BASEMENT, AN ATTIC, A GARAGE OR ANY CONFINED SPACE...
- Page 18 9. APPLIANCE SET-UP 9.1 GENERAL...
- Page 19 10. WIRING DIAGRAM...
- Page 20 11. EXPLODED VIEWS AND PARTS LIST DP00070 DP00072 AND DP00071...
- Page 26 IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement parts for your stove, please provide the model number and the serial number. We reserve the right to change parts due to technology upgrade or availability. Contact an authorized dealer to obtain any of these parts. Never use substitute materials.
- Page 27 Part Description...
- Page 28 Part Description...
Need help?
Do you have a question about the HEP55 and is the answer not in the manual?
Questions and answers