Page 2
Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................5 3. INSTALLATION....................7 4. PRODUCT DESCRIPTION................11 5.
Page 3
• Keep all packaging away from children and dispose of it appropriately. • WARNING: The appliance and its accessible parts become hot during use. Keep children and pets away from the appliance when in use and when cooling down. • If the appliance has a child safety device, it should be activated.
Page 4
• Do not use the appliance before installing it in the built-in structure. • Do not use a steam cleaner to clean the appliance. • If the glass ceramic surface / glass surface is cracked, switch off the appliance and unplug it from the mains. In case the appliance is connected to the mains directly using junction box, remove the fuse to disconnect the appliance from power supply.
Page 5
2. SAFETY INSTRUCTIONS • Before carrying out any operation make This appliance is suitable for the following sure that the appliance is disconnected markets: UA KZ from the power supply. • Make sure that the parameters on the 2.1 Installation rating plate are compatible with the electrical ratings of the mains power supply.
Page 6
2.3 Gas connection • Make sure that the ventilation openings are not blocked. • Do not let the appliance stay unattended CAUTION! during operation. When using a gas cylinder, always keep • Set the cooking zone to “off” after each it on a flat horizontal surface (with the use.
Page 7
have to move them on the cooking • Clean the appliance regularly to prevent surface. the deterioration of the surface material. • To prevent spills, use only stable • Switch off the appliance and let it cool cookware with the correct shape and down before cleaning.
Page 8
Choose fixed connections or use a flexible • the fastening clamps are not rusted; pipe in stainless steel in compliance with the • expired term is not due. regulation in force. If you use flexible metallic If one or more defects are visible, do not pipes, be careful they do not come in touch repair the pipe, but replace it.
Page 9
3.6 Connection cable • from liquid gas to natural gas G20 13 mbar, undo the bypass screw about To replace the connection cable use only the 1/2 of a turn. special cable or its equivalent. The cable type • from liquid gas to natural gas G20 20 is: H03V2V2-F T90.
Page 10
CAUTION! Install the appliance only on a worktop with flat surface. 3.8 Possibilities for insertion The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit with door min 6 mm min 30 mm min 5 mm...
Page 11
4. PRODUCT DESCRIPTION 4.1 Cooking surface layout Semi-rapid burner Control knobs 4.2 Control knob Symbol Description no gas supply / off position ignition position / maximum gas supply Rapid burner minimum gas supply Auxiliary burner 5. DAILY USE 5.2 Ignition of the burner WARNING! Refer to Safety chapters.
Page 12
WARNING! Do not keep the control knob pushed for The spark generator can start more than 15 seconds. If the burner does automatically when you switch on the not light after 15 seconds, release the mains, after installation or a power cut. It control knob, turn it into off position and is normal.
Page 13
7.3 Removing pan supports WARNING! To keep the pan supports in the correct Do not use knives, scrapers or similar position, they are put on metal pins installed instruments to clean the surface of the in the rear side of the hob. For easier glass or the rims of the burners and the cleaning, pan supports can be removed from frame (if applicable).
Page 14
7.4 Cleaning the hob 7.5 Cleaning the spark plug • Remove immediately: melted plastic, This feature is obtained through a ceramic plastic foil, sugar and food with sugar, ignition candle with a metal electrode. Keep otherwise, the dirt can cause damage to these components well clean to prevent the hob.
Page 15
8.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this C.
Page 16
9.3 Other technical data Gas original: G20 (2H) 20 mbar 7,95 kW TOTAL POWER: Gas replace‐ G30/G31 (3B/P) 30/30 mbar 553 g/h ment: G20 (2H) 13 mbar 7,75 kW Electric supply: 220-240 V ~ 50-60 Hz Appliance category: II2H3B/P Gas connection: G 1/2"...
Page 17
10. ENERGY EFFICIENCY 10.1 Product Information according to EU Ecodesign regulation Model identification KGG6426K Type of hob Built-in hob Number of gas burners Left rear - Rapid 54.9% Right rear - Semi-rapid 57.6% Energy efficiency per gas burner (EE gas burner)
Need help?
Do you have a question about the KGG6426K and is the answer not in the manual?
Questions and answers