Scott ADDICT RC 2025 Manual page 7

ADDICT RC
REAR BRAKE CABLE ROUTING
01
Place the rubber grommet into the cable entry hole on the left chain stay. Route
the rear brake cable (blue) through the chainstay and over and past the bottom
bracket. Install a foam protection tube over the rear brake cable inside the frame
(do not overlap the foam into the headtube area).
02
Guide the rear brake cable (blue)
around the driveside of the fork
steerer, exit the cable on the driveside
of the top cap. Exit on the drive side of
the bar. Route the rear brake around
the non-driveside of the steerer for
the UK.
ADDICT RC
(illustration only)
03
3
T 25
Fix the cable cover to the stem.
Torque: 2Nm
Adjust the handlebar and tighten the
stem and steerer bolts, Torque: 5Nm
2025 ADDICT RC | ENGLISH 7 |