Jack Richeson Mantoya How To Assemble

Imported Easels by Jack Richeson & Co., Inc. - Kimberly, WI - Phone: 1-800-233-2404 - www.richesonart.com
Assembly instructions for the Mantoya Easel.
A. Easel Frame & Back Support Leg
D. Mast
Step One:
To attach the Mast (D) to the Easel Frame (A), you will need a Phillips
screwdriver. Insert the plastic dowels into the Hinged Support Piece,
and use the 2 /
3 " Wood Screw to secure.
8
Note: For permanent stability apply wood glue to the dowels
before attaching.
Step Two:
Attach the back of the Mast to the Mast Support Piece using
the hardware already attached. Tighten Knob at desired angle.
Step One
Hinged Support Piece
B. Top
Canvas Holder
Mast
HOW TO ASSEMBLE THE
Mantoya Easel
#886002 Made from Lyptus ® Wood
Lyptus ® is a registered trademark of Weyerhaueser.
Parts Bag Contains:
2 /
3
" Wood Screw
8
4 - /
11
16
2 - 1 /
3
2 - /
3
4
2 - /
3
4
2 - 2
3
2 - 1 /
5
2 - 2
3
Step Two
Step Three
and Four
Step One
Mast Support
Piece with
Hardware: for
angle adjusting
C. Bottom
Canvas Holder
" Screws
" Black Knobs
8
" Plastic Washers
" Brass Washers
/
" Brass Plates (for single bolt)
8
" Bolts
8
/
" Brass Plates (for double screws)
8
3/08
Parts Bag
Step Two