Table of Contents
Advertisement
Tips
•
If you're wearing the headset, you hear ascending tones when the power turns on and
descending tones when the power turns off.
•
When you receive a call, your phone may ring before your headset rings. Wait until you
hear the ring in your headset before you press the call control button to answer the
call.
•
For best performance, position your phone on the same side of your body as your
headset.
•
To quickly re-connect to your recently used device that is within range, briefly press
the call control button.
•
To cancel an outgoing call, briefly press the call control button.
uSiNg YOur hEAdSET
Answering/Ending/making Calls
with PerSonoCall on an internet calling
application
To make a call, simply dial the number via your internet calling application.
To answer or end a call, press the call control button.
When using PerSonoCall, the radio link between the headset and the USB Bluetooth
adapter will only be active during a call. This is the default setting intended to preserve the
battery life of the headset. However, you may wish to have the radio link active when not
on a call so you can listen to other audio sources, such as streaming audio on your PC.
NOTE:
Locking the radio link on for extended periods of time will significantly reduce the standby
and talk time of the headset.
For internet calling applications Not Compatible with PerSonoCall
Check the PerSonoCall compatibility list at www.plantronics.com/personocall for the most
current information on internet calling application compatibility.
If your internet calling application is not currently supported by PerSonoCall, remote
detection and answer/end via the headset does not function. Pressing the call control
button on the headset will only open and close the radio link providing audio; you must
answer the call from the internet calling application.
12
iNdiCA TOr LighTS
HEadSET iNdiCaTOr ligHTS
action
Charging
Fully charged
Low battery
Pairing
Paired
Turning on
Standby
Missed call
Out of range
Back in range
Turning off
TiP:
To reset the missed call indicator, press the call control button once.
BluETOOTH uSB adaPTEr iNdiCaTOr ligHTS
action
Disconnected from the Headset
Connected to the Headset
Radio Link Active
Pairing Mode
rANgE
To maintain a connection, keep your headset within 33 feet (10 metres) of the Bluetooth
device. If there are obstacles between your headset and the device you may experience
interference. For optimal performance, place your headset and phone on the same side of
your body.
As you move out of range, audio quality degrades. When you are far enough away to lose the
connection, you hear a high tone in the headset. The headset attempts to reconnect after 30
seconds. If you move back in range later, you can manually reconnect by pressing the call
control button.
NOTE:
Audio quality is also dependent upon the device with which the headset is paired.
0
0
light
Solid red
None
Double red flash every 10 seconds
Flashes red and blue
Flashes blue
Solid blue for 2 seconds
Blue flash every 10 seconds
Flashes purple every 10 seconds
None
1 blue flash
Solid red for 4 seconds
light
Flashes Purple
Solid Blue
Flashes Blue
Flashes red and blue
Tone
None
None
2 high tones every
30 seconds
1 low tone
1 low tone
Ascending tones
None
None
1 high tone
1 low tone
Descending tones
13
Advertisement
Table of Contents
