Beghelli BBX-SE Installation Instructions

Read & Follow All Safety Instructions
When using electrical equipment, basic safety precautions should always be followed including:
1.
Disconnect power before performing work on electrical equipment
2.
Do not use outdoors
3.
Do not mount in hazardous locations nor near gas or electric heaters
4.
Do not let power cords touch hot surface
5.
Equipment should be mounted in locations and at heights where it will not be subjected to tampering
6.
The use of accessory equipment not recommended by Beghelli Inc. may cause an unsafe condition, and will void
the unit's warranty
7.
Do not use this equipment for other than its intended purpose
Servicing of this equipment should be performed by qualified service personnel
8.
Allow battery to charge for 24 hours before first use
9.
10. DO NOT install in unstable, loose or breakable surfaces
11. DO NOT let objects impact or exert force on the surface of the fixture
LAMP AIMING
INSTALLATION INSTRUCTIONS
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
MAINTENANCE
Battery will have to recharge if the product is kept in stock for over 12 months. We recommend
that the equipment be tested regularly in accordance with local codes. Replace the batteries as
needed if the discharge time is less than 90 minutes.
OPERATION
Press the test button. The LED heads will turn on and the LED indicator will turn off. When releasing
the test switch, the LED indicator will turn on and the LED heads will turn off.
TROUBLESHOOTING GUIDE
If LED lamps or LED indicator do not illuminate, check the following:
1.
Check AC supply - verify that unit has 24 hours AC supply
2.
Check the battery connection
3.
Discharge battery, then permit unit to charge for 24 hours before re-test
4.
If above troubleshooting hints do not solve problem, contact factory for assistance
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
Page 1 of 2
BBX-SE
BBX-SE-HO
01/02/25