Advertisement
Flex-Pad
The Flex-Pad allows the CI 9060 to drive from 1 to 6 independent
zones, in any configuration of stereo or mono (or in mixed
combination), without resorting to the confusion, sonic
degradation, and questionable reliability of switches. Instead, the
Flex-Pad uses the tried and true patch-bay concept to configure the
amplifier channels. The configuration is visually obvious, making
it easier for technicians to set up the system and to troubleshoot
for system errors. The supplied patch cables can be easily
reconfigured or replaced. This can be especially important and can
greatly simplify future service calls years down the road (especially
if system documentation is missing or incomplete).
ATO Logic
The CI 9060 can be turned on in any one of three ways, for
complete system flexibility:
1.
From the front panel switch.
2.
Via the 12 volt trigger circuit.
3.
By a switchable "sleep/wake" signal-sensing circuit.
SPECIFICATIONS
Continuous Power, 20Hz-20kHz, all channels
driven simultaneously at 4/6Ω
Total Harmonic Distortion
20Hz-20kHz at rated power
Clipping Power (0.1% THD)
IHF dynamic power at 6Ω
IHF dynamic power at 4Ω
IM Distortion (SMPTE 60Hz+7kHz)
IM Distortion (CCIR 19kHz+20kHz)
Damping factor (6Ω, 20Hz-20kHz)
NAD Electronics International reserves the right to change specifications or features without notice. NAD is a registered trademark of NAD Electronics
International. All rights reserved. No part of this publication may be reproduced, stored, or transmitted in any form whatsoever without the written
6 x 80W
0.03%
90W
85W
90W
>0.08%
>0.08%
31
permission of NAD Electronics International. © 02/04 NAD Electronics International.
www.NADelectronics.com
This is managed by the Automated Turn-On Logic (ATO Logic)
circuit that requires the amplifier to be switched back to standby
in the same manner by which it was activated. In other words, if
it is switched on via a 12V control signal, it cannot be switched to
standby via the front-panel switch, it must wait for the 12V signal.
Summary
High power, bullet-proof reliability, absolute protection and safety,
combined with flexibility and NAD sound quality make the CI 9060
unique in the world of custom installation. Very small physical size
and the standard rack mount kit (3U) are just icing on the cake (The
CI 9060's big brother, the 12 channel CI 9120 is the same physical
size, making the future expansion easy). Individual level trims for
each channel help make installation faster and easier. This is a new
kind of amplifier that brings NAD's core values of performance,
value, and simplicity to the custom installation market place.
Input impedance
Input sensitivity
Voltage gain
Frequency response -3dB at: 75W
Signal/noise ratio; ref 1W
Physical Specifications
Dimensions (W x H x D)
Net Weight
Shipping Weight
25kΩ
1.1 volts for 8W/6Ω
28dB
5Hz to 45kHz
89dB
17 3/16 x 5 1/4 x 17 3/4"
(435 x 133 x 450 mm)
58 lbs (26.4kg)
68 lbs (31kg)
Advertisement
