Table of Contents
Advertisement
12
1
2
Pull the wheel backwards, removing it from
the swing arm from behind, carefully
removing the disc from the brake caliper.
NOTE
The left spacer ring (10) and the
right spacer ring (11) remain locate in their
seats on the wheel; but if they have come
out of their seats retrieve them.
NOTE
The torque plate (12) of the brake
caliper (13) remains installed on the right
side of the rear fork.
Proceed with care. If the final drive unit
(14) is installed on the flexible coupling
holder (15), do not overturn or rotate the
rear wheel in horizontal position on the rear
sprocket side (A), since the final drive unit
would come off and fall, and this may
damage the rear sprocket (9).
NOTE
If the wheel is in the normal
running position (vertical) or in horizontal
position with the rear sprocket facing
upwards and in both cases secured
against overturning, it is not necessary to
remove the final drive unit.
17
3
6
13
NOTE
Do not unscrew the five nuts (16).
The complete final drive unit must be
withdrawn from the flexible coupling
holder.
Working (B) with both hands on the outer
diameter of the sprocket (9), withdraw
the final drive unit parallely to the wheel
axis.
REASSEMBLY
If the final drive unit has been removed
(14):
NOTE
Introduce the final drive unit,
parallely to the wheel axis, inserting the
flexible couplings in the corresponding
seats on the flexible coupling holder (15).
Working (C) with both hands on the
outer diameter of the sprocket (9), insert
the final drive unit in the flexible coupling
holder (15).
6
3
8
11
9
7
5
12
13
16
9
CAUTION
While reassembling the rear wheel, be
careful not to damage the brake line, the
disc and the pads.
NOTE
Perform the follow operation only if
the left spacer ring (10) and/or the right spacer
ring (11) have come out of their seats on the
wheel:
Install the left (10) and right (11) spacer
rings in their seats on the wheel with the
larger diameter towards the outside of the
vehicle (see figure).
CAUTION
Before proceeding with the reassembly,
make sure that the torque plate (12) of the
brake caliper (13) is positioned correctly;
the plate slot must be inserted in the
appropriate stop pin (17) in the inner part
of the right side of the swinging arm. Insert
the disc in the brake caliper carefully.
use and maintenance RSV 1000 R
USA
15
14
10
7
4
5
113
- RSV 1000 RFACT
USA
Hide quick links:
Advertisement
Table of Contents
