Page 1
Instruction of use EN Induction ceramic hob WIP60SQW4 / WIF60SQW4 / WIP70SQW4 / WIF70SQW4 / WIP78SQW4 / WIF78SQW4 / WIP90SQW4 / WIF90SQW4...
Page 2
SUMMARY SAFETY ............................3 ......................3 RECAUTIONS BEFORE USING ........................4 SING THE APPLIANCE ................5 RECAUTIONS NOT TO DAMAGE THE APPLIANCE ................6 RECAUTIONS IN CASE OF APPLIANCE FAILURE ........................6 THER PROTECTIONS DESCRIPTION OF THE APPLIANCE ................... 7 .......................
Page 3
SAFETY Precautions before using • Unpack all the materials. • The installation and connecting of the appliance have to be done by approved specialists. The manufacturer can not be responsible for damage caused by building-in or connecting errors. • To be used, the appliance must be well-equipped and installed in a kitchen unit and an adapted and approved work surface.
Page 4
Using the appliance • Switch the heating zones off after using. • Keep an eye on the cooking using grease or oils: that may quickly ignite. • Be careful not to burn yourself while or after using the appliance. • Make sure no cable of any fixed or moving appliance contacts with the glass or the hot saucepan.
Page 5
Precautions not to damage the appliance • Raw pan bottoms or damaged saucepans (not enamelled cast iron pots,) may damage the ceramic glass. • Sand or other abrasive materials may damage ceramic glass. • Avoid dropping objects, even little ones, on the vitroceramic. •...
Page 6
Precautions in case of appliance failure • If a defect is noticed, switch on the appliance and turn off the electrical supplying. • If the ceramic glass is cracked or fissured, you must unplug the appliance and contact the after sales service. •...
Page 7
DESCRIPTION OF THE APPLIANCE Technical characteristics Type WIP60SQW4 WIF60SQW4 WIP78SQW4 WIP90SQW4 WIP70SQW4 WIF78SQW4 WIF90SQW4 WIF70SQW4 Total power 7400 W 11100 W 11100W Energy consumption for the hob EC ** 187.4 Wh/kg 188 Wh/kg 183.6 Wh/kg Front left heating zone 220x180 mm...
Page 8
Proper placement of cookware Caution: For optimal effect, it is important that the pan is placed centered over the zones (see diagram). WIP60SQW4 WIP90SQW4 WIP70SQW4 WIP78SQW4 WIF60SQW4 WIF90SQW4 WIF70SQW4 WIF78SQW4 Control panel Timer display Keep warm Bridge Timer Power display...
Page 9
USE OF THE APPLIANCE Display Display Designation Description Zero The heating zone is activated. 1…9 Booster level Selection of the cooking level. No pan detection No pan or inadequate pan. Heat accelerator Automatic cooking. Error message Electronic failure. Residual heat The heating zone is hot.
Page 10
STARTING-UP AND APPLIANCE MANAGEMENT Before the first use Clean your hob with a damp cloth, and then dry the surface thoroughly. Do not use detergent which risks causing blue-tinted colour on the glass surface. Induction principle An induction coil is located under each heating zone. When it is engaged, it produces a variable electromagnetic field which produces inductive currents in the ferromagnetic bottom plate of the pan.
Page 11
Starting-up • Start up / switch off the hob: Action Control panel Display To start press key [ [ 0 ] To stop press key [ nothing or [ H ] • Start up / switch off a heating zone: Action Control panel Display...
Page 12
• Power management: The table is divided in 2 or 3 separate sets of heating zones, each set having a maximum power. WIP60SQW4 WIP90SQW4 WIP70SQW4 WIP78SQW4 WIF60SQW4 WIF90SQW4 WIF70SQW4 WIF78SQW4 If the selected heating levels for both zones exceed the maximum available amount of power, the power management function is automatically reducing the power from one of these zones.
Page 13
• Egg timer function : Egg timer is an independent function. It stops as soon as a heating zone starts up. If the egg timer is on and the hob is switched off, the timer continues until time runs out. Action Control panel Display...
Page 14
Recall Function After switching off the hob [ ], it is possible to recall the last settings. • cooking stages of all cooking zones (Booster) • minutes and seconds of programmed cooking zone-related timers • Keep warm function • Automatic cooking The recall procedure is following: •...
Page 15
Grill Function Action Control panel Display Activate the hob Press key [ [ 0 ] put the grill plate on the 2 zones to use ] blink Activate the Grill Press simultaneously on the « SLIDER » of the 2 cooking zones Slide on the “SLIDER“...
Page 16
COOKING ADVICES Pan quality Adapted materials: steel, enamelled steel, cast iron, ferromagnetic stainless-steel, aluminium with ferromagnetic bottom. Not adapted materials: aluminium and stainless-steel without ferromagnetic bottom, cupper, brass, glass, ceramic, porcelain. The manufacturers specify if their products are compatible induction. To check if pans are compatibles: •...
Page 17
Examples of cooking power setting (the values below are indicative) 1 to 2 Melting Sauces, butter, chocolate, gelatine Reheating Dishes prepared beforehand 2 to 3 Simmering Rice, pudding, sugar syrup Defrosting Dried vegetables, fish, frozen products 3 to 4 Steam Vegetables, fish, meat 4 to 5 Water...
Page 18
WHAT TO DO IN CASE OF A PROBLEM The hob or the cooking zone doesn’t start-up: • The hob is badly connected on the electrical network. • The protection fuse cut-off. • The looking function is activated. • The sensitive keys are covered of grease or water. •...
Page 19
The control panel displays [ U400 ] : • The hob is not connected to the network. Check the connection and reconnect the hob. The control panel displays [ Er47 ] : • The hob is not connected to the network. Check the connection and reconnect the hob. If one of the symbols above persists, call the after sales service.
Page 20
Type Width Depth Width Depth Thick Width Depth Thick Radius WIP60SQW4 WIF60SQW4 WIP70SQW4 WIF70SQW4 WIP78SQW4 WIF78SQW4 WIP90SQW4 WIF90SQW4 • Ensure that there is a distance of 50 mm between the hob and the wall or sides. • The hobs are classified as “Y” class for heat protection. Ideally the hob should be installed with plenty of space on either side.
Page 21
• Materials which are often used to make worktops expand on contact with water. To protect the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to applying the adhesive joint supplied with the hob to prevent any leakage into the supporting furniture.
Page 22
4 zones Country Mains Connection Cable diameter Cable Protection calibre H 05 VV - F 230V~ 50/60Hz 1 Phase + N 3 x 2,5 mm² 25 A * H 05 RR - F H 05 VV - F 400V~ 50/60Hz 2 Phases + N 4 x 1.5 mm²...
Page 23
GUARANTEE A two year guarantee on manufacture and material defects is granted on your new appliance valid from the documented purchase date. The guarantee includes materials, salary and transport. When contacting service please state the appliance model and serial number. The guarantee does not cover: •...
Need help?
Do you have a question about the WIP60SQW4 and is the answer not in the manual?
Questions and answers