Logicube WriteProtect USB User Manual page 27

6.0 Updating/Loading/Re-loading New Software
The latest WriteProtect-USB software, manual, and readme file (which contains the software release
notes) can always be found on the WriteProtect-USB support page at
https://www.logicube.com/knowledgebase/writeprotect/.
The WriteProtect-USB software release may contain both a software and firmware update. This chapter
details how to update/reinstall the software and firmware.
6.1 Requirements
To perform the software update/reinstall, one of the following is required:
The WriteProtect-USB connected to a network with Internet access (for updating "FROM
•
NETWORK"), or
The WriteProtect-USB with your own USB flash drive. The USB flash drive must be formatted
•
FAT32 or NTFS (for updating "FROM USB DRIVE")
6.2 Updating/Reinstalling the Software
There are two methods available to update/reinstall the WriteProtect-USB software:
FROM NETWORK – Over the Internet through a network connection.
•
FROM USB DRIVE – Through a software file download onto a USB flash drive.
•
6.2.1 From Network (Over the Internet)
The WriteProtect-USB software can be updated/re-installed by connecting the WriteProtect-
USB to a network with Internet access.
It is recommended to disconnect any
connected drive from the WriteProtect-
USB before the update/reinstall process.
Connect the WriteProtect-USB to a network with Internet access and turn the
1.
WriteProtect-USB on.
Using the web interface (see
2.
the WriteProtect.
From the main menu on the WriteProtect-USB, click Software Updates on the left side.
3.
Logicube WriteProtect-USB User's Manual
6: Updating/Loading/Re-loading Software
Section 4.1 for details on the web interface), connect to
21