ZyXEL Communications VSG1432-B101 - V1.10 Manual page 288

Chapter 28 Remote Management
Click Maintenance > Remote Management > TR-069 Client to open the
following screen. Use this screen to configure your ZyXEL Device to be managed
by an ACS.
Figure 134 Maintenance > Remote Management > TR-069 Client
The following table describes the fields in this screen.
Table 105 Maintenance > Remote Management > TR-069 Client
LABEL
Inform
Inform Interval
ACS URL
ACS User Name
ACS Password
WAN Interface
used by TR-069
client
Display SOAP
messages on
serial console
Connection
Request
Authentication
Connection
Request User
Name
288
DESCRIPTION
Select Enable for the ZyXEL Device to send periodic inform via TR-069
on the WAN. Otherwise, select Disable.
Enter the time interval (in seconds) at which the ZyXEL Device sends
information to the auto-configuration server.
Enter the URL or IP address of the auto-configuration server.
Enter the TR-069 user name for authentication with the auto-
configuration server.
Enter the TR-069 password for authentication with the auto-
configuration server.
Select a WAN interface through which the TR-069 traffic passes.
If you select Any_WAN, you should also select the pre-configured
WAN connection(s).
Select Enable to show the SOAP messages on the console.
Select this option to enable authentication when there is a connection
request from the ACS.
Enter the connection request user name.
When the ACS makes a connection request to the ZyXEL Device, this
user name is used to authenticate the ACS.
VSG1432-B101 Series User's Guide