Led Descriptions; Setting Up Your Computer's Ip Address - ZyXEL Communications VANTAGE RADIUS 50 Quick Start Manual

2.3 LED Descriptions

LABEL COLOR
PWR Green
SYS Green
ETHERNET Amber
Green

3 Setting Up Your Computer's IP Address

Skip this section if your computer is already set up to accept a dynamic IP
address. This is the default for most new computers.
The device is already set up to assign your computer an IP address. Use this section to set up your
computer to receive an IP address or assign it a static IP address in the 192.168.1.4 to 192.168.1.254
range with a subnet mask of 255.255.255.0. This is necessary to ensure that your computer can
communicate with your device.
Your computer must have an Ethernet card and TCP/IP installed. TCP/IP should already be installed
on computers using Windows NT/2000/XP, Macintosh OS 7 and later operating systems.
3.1 Windows 2000/NT/XP
1. In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel.
2. In Windows XP, click Network Connections.
In Windows 2000/NT, click Network and Dial-up Connections.
Vantage RADIUS 50 Quick Start Guide
STATUS
On Vantage RADIUS is receiving power.
Off Vantage RADIUS is not receiving power.
On Vantage RADIUS is online.
Blinking Vantage RADIUS is restarting.
Off Make sure that you have the correct power adaptor connected to the
device and plugged in to an appropriate power source. Check all cable
connections.
If the LED still does not turn on, you may have a hardware problem. In
this case, you should contact your local vendor.
On Vantage RADIUS has established a 100Mbps network connection.
Blinking Vantage RADIUS is transmitting or receiving data across the LAN Port.
Off Vantage RADIUS doesn't have a 100Mbps Ethernet connection.
On Vantage RADIUS has established a 10Mbps network connection.
Blinking Vantage RADIUS is transmitting or receiving data across the LAN Port.
Off Vantage RADIUS doesn't have a 10Mbps Ethernet connection.
DESCRIPTION
4