Interface Technical Reference - ZyXEL Communications USG-300 - V2.20 ED 2 Manual

Chapter 13 Interfaces
Table 84 Configuration > Network > Interface > Add (continued)
LABEL
Metric
Interface
Parameters
Egress
Bandwidth
Ingress
Bandwidth
OK
Cancel

13.12 Interface Technical Reference

Here is more detailed information about interfaces on the ZyWALL.
IP Address Assignment
Most interfaces have an IP address and a subnet mask. This information is used to
create an entry in the routing table.
Figure 291 Example: Entry in the Routing Table Derived from Interfaces
Table 85 Example: Routing Table Entries for Interfaces
IP ADDRESS(ES)
100.100.1.1/16
200.200.200.1/24
364
DESCRIPTION
Enter the priority of the gateway (if any) on this interface. The
ZyWALL decides which gateway to use based on this priority. The
lower the number, the higher the priority. If two or more gateways
have the same priority, the ZyWALL uses the one that was configured
first.
Enter the maximum amount of traffic, in kilobits per second, the
ZyWALL can send through the interface to the network. Allowed
values are 0 - 1048576.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the
ZyWALL can receive from the network through the interface. Allowed
values are 0 - 1048576.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
DESTINATION
ge1
ge2
ZyWALL USG 300 User's Guide