Related Manuals for Mcombo 6160-R7070
Summary of Contents for Mcombo 6160-R7070
- Page 1 OWNER'S MANUAL LIFT RECLINER (Medium Wide) 6160-R7070 www.mcombo.com / sales@mcombo.com NEWACME LLC mcombo.com amazon.com/mcombo...
- Page 2 SUPPORT shields or other safety features of this product. • Fabric Care You will not refuse or neglect any retrofit kits that MCombo may provide to enhance • Faux Leather Care and preserve the safe use of this product. • Electronics Care •...
- Page 3 • Do not use pillow, blanket, or other cover between occupant and chair surface when heat is engaged. • Do not a�empt to disconnect the power plug by pulling the power cord. Always hold the power Read the safety and other instruc�ons thoroughly before using your MCombo® product. Failure to plug and pull it out.
- Page 4 We are not and cannot be held responsible for any damage or injury incurred due to improper or unsafe USB power use of the MCombo Power Li� Recliner. We specifically disclaim responsibility for any bodily injury or specifica�ons Power ( Single ) 7.5W...
- Page 5 No�ce 1. Ensure the armrest which has USB charge port is located on right of seat. • Use MCombo parts only for all replacements. 2. Slide the le� and right armrest into the brackets of the seat. 3. Press each armrest down as far as it will go (Figure).
- Page 6 Step2 - Backrest Assembly Step3 - Li� Connec�ons 1. Align the brackets of backrest at the clips of seat-back (Figure). 1. Connect the chairs according to the following wiring diagram (Figure). 2. Push firmly the brackets into the seat-back. Listen for a “click” on each side to ensure the 2.
- Page 7 Step4 - An�-back-�pping Part Assembly Step5 - Final Check 1. Place the An�-back-�pping parts (G) near the bo�om of base. 1. Make sure both metal brackets on each armrest are mounted on the base. 2. Align the screws with the holes then �ghten the wing screws (Figure). (There are two metal brackets on each side of the base, it looks like assembly finished when you insert armrest into only one bracket instead of two, however all pressure will apply to one bracket, that is one likely reason that the armrest fall apart from the seat.)
- Page 8 If you discover a problem at any point during the setup and posi�oning of your li� chair,stop and contact the MCombo Customer Support immediately. To avoid personal injury and/or product damage, do not plug the unit into the electrical outlet un�l the problem is corrected and do not...
- Page 9 IV. CARE AND MAINTENANCE Massage Remote Opera�on Instruc�on Your MCombo product will provide years of superior performance and sa�sfac�on with regular care and maintenance. To maintain the finish quality of your "assistant", please follow the guidelines and cleaning procedures provided below.
- Page 10 • Check if the light of the RED bu�on at the back of the base is on. ● Contact MCombo Customer Support if damage is present, do not fix it by yourself. • Check all the electrical cords are not crimped or pinched.
- Page 11 • If there is a burning smell, unplug the remote and contact Mcombo support to replacement. IMPORTANT: If the li� recliner s�ll does not operate properly, please contact the Mcombo® Customer Support for help and never a�empt to make any repairs or adjustments yourself.
- Page 12 Step3 - Remove Bolts Step4 - Replace the New Li� Motor Insert bolts and paper clips at both ends of the li� motor. ( 1 ) The original posi�on of the paper clip ( 2 ) Twist the paper clip ( 3 ) Pull out the paper clip (1) Insert the bolt (2) Insert the paper clip...
- Page 13 Step5 - Plug in the Wire of Li� Motor Step6 - Final Check Check & Confirm NOTE: Please make sure all wires are not been crushed or pulled. 1.Make sure bolts and paper clips are fully inserted. 2.Make sure the li� motor is installed in the correct direc�on. 3.Make sure the wires are not crushed by the seat frame.
- Page 14 VI. DISASSEMBLY INSTRUCTION Step3 - Disassemble Armrest NOTE: No�ce • Need to remove the backrest first. • It is best to remove armrest by two people. • Ensure the chair is in seated posi�on and its footrest return to original posi�on. •...
- Page 15 • If you have any problem to return the product, please contact us immediately, we will do our best to MCOMBO® will pay standard shipping rates on all warranted parts for the first year. We can also sell help you with a reasonable solu�on.
- Page 16 IX. MCOMBO CUSTOMER SUPPORT If for any reason, we have fallen short of your expecta�ons, or if you have any ques�ons and suggests, please refer to the following contact informa�on, we will do our best to work with you to make sure you are en�rely sa�sfied.
Need help?
Do you have a question about the 6160-R7070 and is the answer not in the manual?
Questions and answers
WHERE IS SERIAL NUMBER LOCATED HOW DO IREGUSTER Wrrenty