Subscribe to Our Youtube Channel
Related Manuals for Mcombo R7510
Summary of Contents for Mcombo R7510
- Page 1 OWNER'S MANUAL LIFT RECLINER R7510/R7561/R7541/R7410 R7092/R7093/R7096/R7045 www.mcombo.com / sales@mcombo.com NEWACME LLC mcombo.com amazon.com/mcombo...
- Page 2 SUPPORT shields or other safety features of this product. • Fabric Care You will not refuse or neglect any retrofit kits that MCombo may provide to enhance • Faux Leather Care and preserve the safe use of this product. • Electronics Care •...
- Page 3 • Do not use pillow, blanket, or other cover between occupant and chair surface when heat is engaged. • Do not a�empt to disconnect the power plug by pulling the power cord. Always hold the power Read the safety and other instruc�ons thoroughly before using your MCombo® product. Failure to plug and pull it out.
- Page 4 USB Power We are not and cannot be held responsible for any damage or injury incurred due to improper or Specifica�ons unsafe use of the MCombo Product. We specifically disclaim responsibility for any bodily injury or 7.5W Power ( Single ) property damage that may occur during any use that does not comply with applicable federal, state, or local laws or ordinances.
- Page 5 • The chair is delivered in MULTIPLE boxes. Please check if you have received all parts of the chair. 1. Place the An�-back-�pping parts (G) near the bo�om of base. • Use MCombo parts only for all replacements. 2. Align the screws with the holes then �ghten the wing screws (Figure).
- Page 6 Step2 - Armrest Assembly Step3 - Backrest Assembly 1. Ensure the armrest which has USB charge port is located on right of base. 1. Align the brackets of backrest at the clips of seat-back (Figure). 2. Slide the le� and right armrest into the brackets of the base. 2.
- Page 7 Step4 - Li� Connec�ons 1. Before a�aching the li� remote and massage remote to the base, please get wires through the side loops of either side armrest according to the user's preference. Step5 - Final Check 1. Make sure both metal brackets on each armrest are mounted on the base. (There are two metal brackets on each side of the base, it looks like assembly finished when you insert armrest into only one bracket instead of two, however all pressure will apply to one bracket, that is one likely reason that the armrest fall apart from the seat.)
- Page 8 If you discover a problem at any point during the setup and posi�oning of your li� chair, stop and contact the MCombo Customer Support immediately. To avoid personal injury and/or product damage, do not plug the unit into the electrical outlet un�l the problem is corrected and do not...
- Page 9 IV. CARE AND MAINTENANCE Massage Remote Opera�on Instruc�on Your MCombo product will provide years of superior performance and sa�sfac�on with regular care and maintenance. To maintain the finish quality of your "assistant", please follow the guidelines and cleaning procedures provided below.
- Page 10 ● Keep all the electronics free from moisture and temperature extremes. ● Check electrical components frequently for signs of corrosion and replace as necessary. ● Contact MCombo Customer Support if damage is present, do not fix it by yourself. • Check all the electrical cords are not crimped or pinched.
- Page 11 • If there is a burning smell, unplug the remote and contact MCombo support to replacement. NOTE: If the li� recliner s�ll does not operate properly, please contact the MCombo® Customer Support for help and never a�empt to make any repairs or adjustments yourself.
- Page 12 Step4 - Replace the New Li� Motor Step3 - Remove Bolts Insert bolts and paper clips at both ends of the li� motor. ( 1 ) The original posi�on of the paper clip ( 2 ) Twist the paper clip ( 3 ) Pull out the paper clip (1) Insert the bolt (2) Insert the paper clip...
- Page 13 Step5 - Plug in the Wire of Li� Motor Step5 - Final Check NOTE: Please make sure all wires are not been crushed or pulled. Check & Confirm 1.Make sure bolts and paper clips are fully inserted. 2.Make sure the li� motor is installed in the correct direc�on. 3.Make sure the wires are not crushed by the seat frame.
- Page 14 VI. DISASSEMBLY INSTRUCTION Step3 - Disassemble Armrests NOTE: No�ce • Need to remove the backrest first. • It is best to remove armrest by two people. • Ensure the chair is in seated posi�on and its footrest return to original posi�on. •...
- Page 15 • If you have any problem to return the product, please contact us immediately, we will do our best to MCOMBO® will pay standard shipping rates on all warranted parts for two years. We can also sell you replacement part for a discount price when your product is out of warranty policy.
- Page 16 IX. MCOMBO CUSTOMER SUPPORT If for any reason, we have fallen short of your expecta�ons, or if you have any ques�ons and suggests, please refer to the following contact informa�on, we will do our best to work with you to make sure you are en�rely sa�sfied.
Need help?
Do you have a question about the R7510 and is the answer not in the manual?
Questions and answers