ZyXEL Communications PLA4205 User Manual page 22

Chapter 3 The ENCRYPT Button
Press the ENCRYPT button at the side of your powerline device for 1~2 seconds. The power (
2
light will blink as the powerline device tries to set up a connection.
Figure 7 ENCRYPT Connection Procedure
Note: The ENCRYPT button's location varies for each Powerline model.
Repeat step
3
within 120 seconds of pressing the ENCRYPT button on the PLA4205.
Note: Check the lights on the two powerline devices. The power (
lights should be blinking while the devices are connecting. Several times all lights
blink simultaneously and the HomePlug (
one minute while your powerline devices connect.
If the power ( ) light does not blink when you press ENCRYPT, you have probably pressed
the ENCRYPT button for too long. Try again, pressing the ENCRYPT button for 1~ 2
seconds.
If the HomePlug (
devices are not connected. Repeat steps 2 and 3 in this section. If that doesn't work, see
the Troubleshooting in Section 6.5 on page 51 for suggestions.
To add more powerline devices to your network, press the ENCRYPT button on device C (shown
4
below) for more than 10 seconds until the power (
22
press 2 seconds
2 in this section for the other powerline device you wish to connect. This must be done
) lights on both powerline devices do not light up, the powerline
within 2
minutes
) light also shows red. Wait for about
) light flashes.
press 2 seconds
) and HomePlug (
PLA4205 User's Guide
)
)