Ouellet OVO Series Installation Manual

WARNING: This product must be installed by a certified electrician according to the electrical and building codes
effective in your region.
Use copper or aluminium wires only. Use supply wires suitable for 194 °F.
WHAT IS IN THE BOX
6 Back box for OVO/H/S series
wall fan heater
6 Self-adhering spacer
Before installing and using this product, you must read and
understand these instructions and keep them for future reference.
If the installer and the user do not follow these instructions, the
manufacturer cannot be held liable in any way and the warranty
will be null and void.
The following instructions must be adhered to in order to avoid
personal injuries or property damages, serious injuries and poten-
tially fatal electric shocks.
If the installer or the user modifies the unit, they will be held re-
sponsible for any damage resulting from this modification, and the
CSA certification could be void.
INTENDED USE
For indoor installation only. Make sure the unit is appropriate
for the intended use (if needed, refer to the product catalog or a
representative).
POSITION
Do not install the unit where objects or pieces of furniture could be
heat damaged.
Respect the following distances and positions: This unit must be in-
stalled at least 6 in. (15 cm) from any adjacent surfaces and at least
6 in. (15 cm) from the floor. Make sure objects or pieces of furniture
such as, but not limited to, blankets, towels, beds, laundry baskets,
clothing, papers, etc. do not come into contact with the unit, and
keep them at least 36 in. (90 cm) from the unit. Some materials are
more heat-sensitive than others, so make sure those near the unit
can withstand heat. Do not install on a wall behind a door.
This unit has hot and arcing or sparking parts inside. It is not de-
signed to be used or stored in wet areas or areas containing flam-
mable liquids, combustible materials or corrosive, abrasive, chemi-
TOOLS REQUIRED
Level
Flat screwdriver
Phillips screwdriver
Tape measure
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
OVO SERIES
OVOH SERIES
OVOS SERIES
Wire clamp
12 (2 per back box) Screws (1-1/2") with a 1/4" (6.5
mm) diameter head minimum, suitable for securing
the back box directly to a stud.
cal, explosive and flammable substances such as, but not limited
to, paint, gasoline, chlorine, sawdust and cleaning products.
RISK OF FIRE, ELECTRIC SHOCK,
BODILY INJURY AND DAMAGE
This product must be installed by a qualified person and con-
nected by a certified electrician, according to the electrical
and building codes effective in your region.
Protect the heating unit with the appropriate circuit breaker or
fuse, in accordance with the nameplate.
Make sure the line voltage (volts) is consistent with that indicated
on the unit's nameplate.
This unit must be grounded.
Switch off the power at the circuit breaker or fuse before installing,
repairing and cleaning the unit.
This unit must not come into contact with a water source and must
be protected from splashes (e.g., splashes from a sink or shower).
Do not use it if any part has been immersed. Moreover, do not turn
it on or off when standing in water or if your hands are wet.
When starting up the unit for the first time or after a long period,
it is normal that it produces some temporary odours.
Because this unit is hot when in use, it may pose risks even in nor-
mal operation. Therefore, be careful and responsible when using
it. To avoid burns, do not let bare skin touch hot surfaces. The unit
must cool down for few minutes since it will stay warm for some
time after shut down.
1
BACK BOX
INSTALLATION GUIDE
INS-OVOBB