Ouellet OVO Series Installation Manual

KIT-OVO-BS-BL
IMPORTANT INSTRUCTIONS
The surface adapter is for use in cases the fan heater cannot be installed
in-wall. It is compatible with OVO and OVOS models only. There are two
knock out locations for quick and easy installation with surface-mounted
power cable & conduit.
During surface installation, the surface adapter serves as a back box,
and the latter must not be installed. Any references to the back box
for subsequent steps in the OVO / OVOS owner's manual should be
interpreted as referring to the surface adapter.
Before beginning installation, refer to the Important instructions section
in your owner's manual.
CUTTING THE POWER SUPPLY
To protect yourself from the risk of electric shock, turn off the power to the lead wires from the electrical panel.
1
PREPARING FOR ELECTRICAL CONNEXION
1. Remove one of the two knock-outs [A].
Note: If the power cable comes from inside the wall, a hole can be drilled
in the back of the surface adapter using proper tools.
A
SURFACE ADAPTER
NOTE: The unit must not be installed
upside down nor sideways.
VERTICAL INSTALLATION
HORIZONTAL INSTALLATION
A
OVO SERIES
OVOS SERIES
WHAT IS IN THE BOX
• Surface adapter
TOOLS AND MATERIAL REQUIRED
• Level
• Electrical fitting
• Wire conduit
• Screwdriver
2. Insert fitting* [B] in the hole and
*Electrical fitting not included
1
INSTALLATION GUIDE
• 4 screws and suitable sup-
ports to hold the device's
weight based on the wall
finishing
• Tools to install the
supports, as needed
secure it in place.
B
INS-OVOBS