Table of Contents
Advertisement
If you installed hardware components separately, an Uninstall Hardware Compo-
nents icon is created in the Dell Node folder. Use this icon to uninstall the hardware
components.
To uninstall a Dell managed node from a NetWare server, perform the following steps
at the NetWare system console prompt:
1.
Type dcuninst and press <Enter>.
2.
Remove the following lines from the autoexec.ncf file under the system
directory:
REM*** Start Dell HIP Section ***
DC_AUTO.NCF
REM*** End Dell HIP Section ***
NOTE: You must delete the dc_auto line and the two remarked ( REM ) lines from the
autoexec.ncf file before attempting to reinstall a Dell managed node to a NetWare
Server.
A modem can be configured for a Dell Remote Assistant Card and for a Dell Remote
Assistant Server service on a management station.
Depending on whether your system is equipped with DRAC or DRAC version 2.0, use
the following instructions to configure a modem.
To support the DRAC feature available on Dell PowerEdge 4100 and 4200 and DRAC-
equipped PowerEdge 2100 and 2200 systems, the US Robotics Sportster 28.8 or a
compatible data/fax external modem connected to the DRAC must be configured to
communicate with the Remote Assistant. To configure the modem, set the modem
switches as shown in Table 2-1.
NOTE: To ensure proper initialization of the modem, always connect the modem to its
power source and turn it on before you turn on the system.
Installation and Upgrade Procedures
2-17
Advertisement
Table of Contents
