ZyXEL Communications NBG4115 - V1.0 Manual page 124

Chapter 9 WAN
Table 44 WAN > Advanced
LABEL
Allow between LAN
and WAN
Allow Trigger Dial
Auto-bridge
Enable Auto-bridge
mode
Apply
Reset
124
DESCRIPTION
Select this check box to forward NetBIOS packets from the LAN to
the WAN and from the WAN to the LAN. If your firewall is enabled
with the default policy set to block WAN to LAN traffic, you also
need to enable the default WAN to LAN firewall rule that forwards
NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the
LAN to the WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Select this option to have the NBG4115 switch to bridge mode
automatically when the NBG4115 gets a WAN IP address in the
range of 192.168.x.y (where x and y are from zero to nine) no
matter what the LAN IP address is.
Click Apply to save your changes back to the NBG4115.
Click Reset to begin configuring this screen afresh.
NBG4115 User's Guide