Download Print this page

OWC Drive Dock Manual page 8

Dual-bay drive docking solution for 2.5/3.5-inch sata & u.2 drives
Hide thumbs Also See for Drive Dock:

Advertisement

3.4 Terms & Conditions of Sale
OWC's products are provided subject to OWC's Terms & Conditions of Sale located
at
Terms of Sale
or other applicable terms. The OWC Drive Dock comes with
a 2 Year Limited Warranty. Additional warranty information can be viewed by visiting
Hardware Warranties
Changes
The material in this document is for information purposes only and subject to
change without notice. While reasonable efforts have been made in the preparation
of this document to assure its accuracy, OWC, its parent, partners, affiliates,
officers, employees, and agents assume no liability resulting from errors or
omissions in this document, or from the use of the information contained herein.
OWC reserves the right to make changes or revisions in the product design or the
product manual without reservation and without obligation to notify any person of
such revisions and changes.
FCC Statement
Warning! Modifications not authorized by the manufacturer may void the user's
authority to operate this device. NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference with radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• • Reorient or relocate the receiving antenna.
• • Increase the separation between the equipment and receiver.
• • Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
Copyrights and Trademarks
No part of this publication may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying,
recording or otherwise, without the prior written consent of OWC.

Advertisement

loading
Need help?

Need help?

Do you have a question about the Drive Dock and is the answer not in the manual?

Questions and answers